Separate names with a comma.
Some features disabled for guests. Register Today.
Check Calibration from Wizard and Tools menu, perhaps their controller used different microstepping.
Did you do your SetZero before clicking Check Size. Did you try the Hello World (good shakedown with a known good gcode)
That really does! Hehe But that means you could try grblHAL as you have an ESP based board?
MisterG you have regular Grbl right? Not grblHAL? One last thing we can try is just latest grblHAL (our included image is from around May 2023)...
Then correct it with $3 until it is correct and once it jogs correctly (do that first) use $23 to tell the controller where the homing switches...
Try restarting controller and PC Are you sure the flash was successful? With the correct firmware on it the buttons should show up on next connect
That's the thing. All of them. Its a different machine. Use the Backup off the Old controller. If it was working, then you know those settings are...
They are Current Adjustment. Not speed. docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] All the way down likely under powers your...
Growing pains. Tell us: We even have Backup / Restor built in to help you transfer old controller's settings Note any other workflow...
Profile or Firmware? Check your machine using pen up/down buttons, and don't forget the Calibration steps (Wizards and Tools menu). Once...
See docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] but irrelevant for the direction config as you can set that with $3. Jog...
1) Interface is a PC replacement. Use one, or the other. Not both [MEDIA] 2) machine just follows the gcode. Check that you set up machine...
That's the X32s docs. And you have the Refer to the correct documentation please :)
And where is the $33 reference you refer to? Where did you read that?
BlackBox 4X or BlackBox X32?
The jumper sets the voltage to what the Switch needs. Most Inductives needs 6-30v and work with the jumper on the default 5V position Note we...
I see. Jog command ran. Content of string did trigger the $G checker (not needed, but shouldnt hurt) But then it was already locked when the...
See the link provided Click the Products tab, use the Filter block to search for "acro" [ATTACH]
G38.3 is probe with no error. Try G38.2 so you can see what the Probing error was? The .3 is hiding the true error that causes the lockout in the...
No, 24v output (coolant) and 3.3v logic signals on some of the other pins. It is a CNC controller after all... That is all documented on...
