Separate names with a comma.
Some features disabled for guests. Register Today.
Opt is a little higher quality and has some really powerful topend models, but in terms.of functionality, life expectancy, etc both are far...
Is your Interface Firmware up to date? (V1.57 at this time) CONTROL and Interface both use the same backend logic. The error states that a) you...
Thanks, just making sure the current adjustments were done as part of initial set up. Please contact the store via Support > New Ticket for...
See docs:blackbox-x32:currentadjustment [OpenBuilds Documentation]
Did you remember to select the Acro from the Grbl Settings tab in CONTROL > Select machine from the list > Save and Reset when Prompted? As its...
One being damaged is already suspect, two in a row indicates with certainty something is damaging them. As you already have been dealing with the...
Well that would be good to mention first (; otherwise the assumption would be that you are - like most people here - needing help with your CNC as...
Correct, then when you load gcode is scales to match the job. Machine size is shown by the light gray "box" Is it co-incedentally just as the...
Correct. YOU the operator are in control at all times. It does what you tell it to do. If you put your INSIDE cut above your OUTSIDE cut (and...
You would have to check in with your plasma inverter's vendor directly for information on availability of compatible accesories for their inverter.
Yip nothing strange there, standard standard (115200N81) The Grbl Wiki is a must read grbl/doc/markdown/settings.md at master ยท gnea/grbl and...
No file attached
Select the inside cut, add it to a toolpath, set that as an inside cut. Select the outside, add it to another toolpath, set as outside
Have not tried it, but please do, report back
Of course not you are just splitting the step/dir/enable signals between two drivers
Huh, why? :eek:
That is correct, current and no known bugs related to streaming. Please post the gcode file Errors 2 and 25 indicate malformed gcode, but could...
Interface Firmware version you are on? (shown at bootup)
Twist them together and insert. And use appropriate sized wires, its a 20mA signal so 0.2mm2 is plenty If you really have to, split it up a...
Refer the Documentation link above ^ Go to BlackBox X32 page, and work through it. Knowing your controller will just be beneficial
