Separate names with a comma.
Some features disabled for guests. Register Today.
Check wiring between probe and controller. LEDs are switched onboard, but the signal never reached the controller Yes, checkout the Tool Offset...
Contact the store via Support for assistance, thanks
Please contact the store via Support > New Ticket for assistance
Check out Tramming: A generic guideline Whatever is skewed could be compounded by something else lower down in the chain too. Key thing is in the...
Check out Tramming: A generic guideline
Contact the store via Support > New Ticket - including pictures of all wiring (unless changed since). Thanks
Well. Lets try a replacement probe first. If the issue persists, its always an option (:
The electrician will own an expensive piece of kit called an Insulation tester. He can use that to test each of the spindle's three phase inputs...
Exactly, whenever someone blames "the update" i do chuckle a bit. OpenBuilds-CONTROL/CHANGELOG.txt at master ยท OpenBuilds/OpenBuilds-CONTROL shows...
Blinking PSU is an indicator of a wiring short or incorrect polarity. Check polarity, check all cabling for shorts. The melted connector is a...
If it stalls with the Red Exclamation, refer the 2nd half of docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] If it does not...
Weekend now, but they'll get a replacement to you next week, then we take it from there.
Depends. Did you contact the store to try a replacement as suggested above?
Whichever controller you end up with, do try to locate the source of damage. In all the years I think of maybe two that got damaged that way - so...
Shouldn't go over 10v so something fried the output opamp. Sorry.
Thanks Ticket already open, dev team will investigate in due time. Thanks for the bug report
Correct..profile was just to ensure that it wasn't a combination of bad fan, and the default profile which doesn't enable motors. Check in with...
Did you remember to load a machine profile? CONTROL > Grbl Settings tab > Select machine from the list > Save and reset when prompted Otherwise...
Should help, but proof will be in the pudding as they say. A test cut will let you know if it helped
Possible, but unlikely. Do reach out to Submit a ticket and we can try PS: that is correct for a 2-wire setup, the lights need power. You want...
