Separate names with a comma.
Some features disabled for guests. Register Today.
You can review the Changelog to see what changed in each version: OpenBuilds-CONTROL/CHANGELOG.txt at master ยท OpenBuilds/OpenBuilds-CONTROL See
M3/4/5, but can be remapped in grblhal with a custom pin map
The onscreen error says either the BlackBox is not properly booted up (usual blinky LEDs on?) Or the USB cable is still plugged in (only USB or...
Did you follow all the setup instructions in docs.openbuilds.com/interface without skipping any steps (retrofit jumper perhaps?)
But did you remember to load a machine profile again? CONTROL > Grbl Settings tab > Select machine from the list >Save > and Reset when Prompted...
V1.0.369 has been released, saving you the extra click (:
You need the above firmware image to swop to relay2. Proceed to get a succesful flash first. Make sure to click on the X32 tab (Bug fixed in...
You can post the grbl settings if you'd like us to review it.
You would also need the thinner endplates (that work with the tension system), thrust bearings, tension nuts, flange bearings, etc. A 1500mm...
Was the funny noise a Whining sound? (Stall. Indicator that either current Adjustment is needed, or Acceleration/Max Rate set too high, or...
Check out https://docs.openbuilds.com/blackbox Super easy, no real Onefinity writeup, as there isn't anything particularly specific. Just wire up...
Well the "right" way to do it, is to create a plugin that does "exactly" what you need it to do: GitHub - grblHAL/plugins: Plugins overview but...
What is the role of the PLC? From the animation I see a conveyor belt, could you not run that from the BlackBox too? Mixing multiple different...
Check earlier in the thread, around post #8?
12v might be a bit on the slow side, have you checked out our 24v powered BlackBox X32? docs:blackbox-x32:start [OpenBuilds Documentation] You...
That's the half-written firmware from the day before, unable to boot of course (it didn't finish writing remember). Usb Extensions are a bad...
Check out section 15 of Terms of Service and Rules | OpenBuilds
Ok, and are you 100% sure your GCODE is Grbl compatible? What if you run the Hello World test? docs:blackbox-4x:hello-world [OpenBuilds Documentation]
No! Fix the machine! :) Standards exist for a reason Simple Invert under $3 Direction Invert in Grbl Settings is all it needs
Also works fine in the latest, you should be fine after updating [ATTACH]
