Separate names with a comma.
Some features disabled for guests. Register Today.
Our recommended vendors has other models - feel free to click on through to their respective websites. For example: PLH3D-15W Laser Head for...
We have a couple Speeds and Feeds charts in the Resources | OpenBuilds section that may be helpful
The test menu on Interface would still not offer variable speed in this config - you'd have to use the VFD front panel - the danger here is a...
M3 = a PWM signal - you want a relay to be ON or OFF - does not like a variable pulse, it will chatter But NB do note the docs, recommend proper...
1) make sure they are wired correctly (Troubleshooting tab in CONTROL while pressing them by hand - make sure a) that they light up in...
Check out Lasers - OpenBuilds Part Store
CONTROL is for connecting to the BlackBox You can invert axes one of three ways - CONTROL > Grbl Settings tab (pc connected to BlackBox) -...
First connect to the controller. Then the Grbl Settings can be accessed.
Position skip is usually mechanical. Loose setscrews on pulley/shaft coupler?
For tech support for the VFD/Spindle itself, the manual, manufacturer, and the vendor you purchased from should be the primary support channels -...
Correct! The mistake was trying to use more modern firmware/software :) The old's fine, as long as its mixed with old :) As far as I know our...
Correct, though it could be used by GrblHAL after bootup - not implemented. But GPIO0 is tied to the button, and one can configure some use case...
The catch comes in when mixing old and new. The 2015 hardware has outlived its relevance a little. You could of course continue using older...
Means the bootloader on the arduino wasn't responding. Possibly a very old one (uno vs older versions of arduino used different bootloaders)....
Confirm it really is, from the Troubleshooting tab. If it was operational it would have worked. Use Troubleshooting tab to see a) that it works...
It doesn't have any known limits - should do that just fine.
In this example just marketing language - same drivers, so same specs? Or did I miss some big typo
Yes, and GrblHAL can also be configured to slave limits off each other (share A and Z on the Z input for example) - we will be posting details in...
OpenBuildsCONTROL > Connect to the controller (Close Lightburn) > Grbl Settings tab You can use the Backup settings button if you want us to...
Then it sounds like the gcode isn't turning off between entities. Make sure your Lightburn is setup correctly docs:software:lightburn [OpenBuilds...
