Separate names with a comma.
Some features disabled for guests. Register Today.
Always always? Or only when the magnet is attached to the collet? If its always-always, measure your boards Probe Input signal pin, to DC gnd....
Keep in mind 445nm diode lasers have lots of trouble with plywood because the inorganic resin glue layers, does not cut. It gets through a wood...
$6=0 is the correct setting. You have a Ground Loop fault somewhere in your machine. Any after market parts like a VFD? Somewhere DC GND is...
See docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation] Loose terminal, or broken wire, or badly installed terminal leading to only...
Depending on the sweep of your servo that might not work, but one rarely Jogs the pen. Jog XY to position job, then SetZERO and run the file
Yes, Whether its a laser, spindle, plotter - no difference all work on the same M3 commands Your GCODE contains the correct commands.
Oh, also keep in mind the grid shows the extent of the job (not your stock) so read the numbers along the axis, it probably is in the right spot,...
Its temporarily removed until it gets fixed (:
CONTROL won't (can't) move your file. Likely you have the origin set to top-right in Vectrics stock setup. Also make sure you are using our Post...
Great, do still see the EMI FAQ about the USB disconnects. Most likely cause for that issue. But also checkout section 4.2 of that same...
Might be best to ask the spindle vendor for assistance. They should be able to advise on correct VFD parameters etc.
Make sure your 24v PSU is plugged directly into the wall (not by accident plugged into your IoT relay? Its not a power strip) Also see...
Make use of the Transform tool (last icon at the bottom) - much more control Mouse move was removed as it has a long standing bug in it
Now you are discovering the tip of the iceberg which is the power of a Modular Build System (;
Rather than the slow and painful jogging using an edge finder, consider getting yourself an https://docs.openbuilds.com/xyzprobe
Also do research on wavelengths. 15w. 445nm. Near UV is only absorbed (ie effective) on organics (leather, paper, wood). Doesnt work so well on...
For that, you can get an enclosed K40 and a Lightburn licence (:
Fair enough (good support sadly comes at a price some times) - well hoping the vendor returns a reply. Otherwise, you may need a little trial and...
