Separate names with a comma.
Some features disabled for guests. Register Today.
Indicating mechanical (go over everything again) Typically when calibrating (if done right) it just keeps getting better and better. too short...
Sorry, but please note the request was: IE, a) a Workspace export (not a GCODE file) and b) via the linked Github Issues and not attached...
That means your Soft Limits or Homing is setup incorrectly. 1) make sure jogs follow cartesian directions 2) use $23 to tell grbl where your...
Then either your calibration is still off (redo, make sure to use longest possible move for the measurement you can enter your own move length in...
Yes, totally normal.
We'd recommend contacting the vendor you purchased it from. Most likely the VFD reset changed their preprogrammed parameters back to defaults.
Thanks for the test. Please contact support.openbuilds.com > New Ticket for further assistance. Please include a link to this thread as it shows...
A current scope on the lines between the laser driver and the actual diode will be able to tell you if the driver is failing, or the diode itself....
Have you contacted the store yet? They will sort you out in no time (:
What laser is it?
Presets just populates the fields below for our Machines. Pick any similar one, scroll down and fix anything that needs fixing (working area etc)
At the end of the day our generic instructions are just that - generic concepts - some lasers take 3 wires (shared GND), some take 4 (seperate GND...
Skip the often misinformed and guesswork filled videos and rather read Home ยท gnea/grbl Wiki - every page in that Wiki has valuable, accurate...
Could be incorrect firmware for the board (with an inverted bitmask on the reset pin) or if that firmware allows configuring buttons in its...
Hit in eye with 1000mw 445nm blue laser is a must read thread OD = optical density. With unknown acrylic you don't have a proper OD rating, nor...
1) Unplug one of your Endstops 2) Plug it into the Probe port (Endstops and Probes shares the same pinout so its a straight swop) 3) Watch the...
1) did you remember to provide Power to the laser? 2) did you enable Laser Mode in Grbl Settings and then also use the correct Laser Submenu under...
Ordinarilly no, we have online portals here and at support.openbuilds.com One has to of course consider what counts as Support (shipping, order,...
Theoretically yes. Apply, reset the BlackBox, then test again
