Separate names with a comma.
Some features disabled for guests. Register Today.
Good plan then - sorry we can't be of more direct help (as we don't know your machine) but if you have the ability, drive and patience to work...
Our recommendation for a custom machine build like this would be to pull the existing machine into CAD, import our parts from our libraries...
If its our Leadscrews, 199.1 steps per mm (Theoretical 200, but in practice the rolling process is a little off and its closer to 199.1) 8mm...
Sounds like signal wire not connected between Probe and BlackBox. Recheck your wiring (cable not broken, terminals tight, no insulation pinched in...
Checkout docs:software:overview [OpenBuilds Documentation] for some options As far as we know the Advanced settings > Climb/Conventional should...
Should be possible yes. Review the BlackBox documentation at https://docs.openbuilds.com/blackbox for an overview
1) Check mechanical components (loose setscrew on shaft coupler, etc) 2) Check Grbl Parameters (Acceleration or Max Rate set too high causing...
Means the Probe is triggered even before it can start the probe. Either your bit is already touching the plate - or your machine has a short...
See Grbl v1.1 Configuration · gnea/grbl Wiki
Thanks for confirming. Please contact the store via Support > New Ticket for further assistance - please include a link to this thread so they can...
I was referring to this: What kind of switches do you have? Assuming its not the Xtension Limits then? Micro Limits? Was NC wired to V+ at any...
Can you explains what exactly was miswired? Which version of BlackBox you have? (can peek into the vents on the back side (opposide side of where...
No, but it has a Pull-up to prevent noise. That's maybe what you are noticing there. Be sure to wire your switches as shown in...
Interface > Tools and Utils > Edit Grbl Settings > scroll down to Steps per mm It is a lot easier to use the Wizards yes. If you have a PC nearby...
No, Grbl does not give you ability to send commands to it while in feedhold (reread the links above please. Commands are only accepted in JOG to...
Grbl's "pause" is a feedhold only. See Grbl v1.1 Commands · gnea/grbl Wiki The Grbl Wiki is a must-read to understand Grbl For a more advanced...
Most likely EMI/Earthing but do check in with the store via Support > New Ticket for the best assistance with this issue
In that scenario, the toolchange may as well be manual too (even if you have a toolchanger, using Macros) in between files. Works fine
David was referring to creating a seperate mygozero.gco file on the USB drive to do a custom go to zero macro. Run it just like you would a job file
OpenBuilds CONTROL > Connect to your controller > Click the Grbl Settings tab. A convenient "Backup Settings" button allows downloading settings...
