Separate names with a comma.
Some features disabled for guests. Register Today.
Very likely the connector is fine, but it is possible for a little human error to sneak in, and accidentally insert the wire under (instead of...
That is not an official support channel, if you need our assistance, please do post here
Best to confirm - Easel has been pushing new "grbl" (their fork) versions on people with a similar prompt (not good) which breaks things
You should disable power saving of all kinds - you were lucky it resumes - more likely can cause machine to run away or disconnect (Serial...
Sometimes one may need an intermediate CAD to clean up some of the more advanced CADs outputs. Here's one example, of how to use QCAD (free) to...
CONTROL > Wizards and Tools > Calibration will help with that. If its very far off, calculate your Z-axis steps per mm in Grbl Settings first...
Both your acceleration and Max Rate values are quite low. See Grbl v1.1 Configuration · gnea/grbl Wiki and Grbl v1.1 Configuration · gnea/grbl...
1) Make sure to convert all splines/arcs/etc to Polylines 2) Make sure your DXF is saved as DXF R14 PolyLine See docs:software:file-errors...
It might be buggy with 360deg circles, but do post a sample file in a git issue, we can take a look
See docs.openbuilds.com/interface > preparing your BlackBox step (depending on version of your BlackBox)
Flip one coilpair's polarity.
Disassemble and reassemble the z axis, give it all a thorough inspection. For example damaged leadnuts, slipping shaft couplers, mechanical...
Post some pictures of your own issues please
It sure saves a bit of work to install it from the beginning, in particular allows you to tram it up perfectly from the beginning: Tramming: A...
See Tramming: A generic guideline - tramming is usually the cause for lines in pocket cuts, due to tilting
Does the crash happen on that initial G53 Z-safe move? Incorrect start/stop Z position value (Positive instead of Negative)? Post the GCODE please
Contact the store via Support > New Ticket and they would be all too happy to sort that one out for for you :)
Initial zoom is set from viewExtents function, used by resetView (called after window resize, file load, button, etc) May need to fudge around...
Cheapie? Or decent controller with optoupled and filtered endstops like an docs.openbuilds.com/blackbox running Xtension Limits
Also consider a real controller, like a https://docs.openbuilds.com/blackbox - the CNC shields are very bare, tiny little drivers barely enough...
