Separate names with a comma.
Some features disabled for guests. Register Today.
Yeah not sure about EstlCAM, see docs:software:fusion360 [OpenBuilds Documentation] and docs:software:vectric [OpenBuilds Documentation] Or just...
In the time since our Post processors have been updated to support breaking up jobs into seperate tool files so you don't need to :)
Also see docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation] Test the motors off machine and see if they move erratically
Sometimes you can forget to fully open the terminal before inserting wires, and thus accidentally insert wires underneath the travelling clamp...
I'd run it a little more till its easy to turn by hand (:
The servo is seen as a toolhead (M3S commands, not Z commands), so just ensure your gcode outputs the required commands by editing the post The 4...
See docs:blackbox:connect-rc-servo [OpenBuilds Documentation] for it's more usual RC servo support options
1) Make sure you followed all the steps in docs.openbuilds.com/interface chronologically 2) Also test your BlackBox against a PC - if it also...
yes, should be fine!
Z- is down toward the bed. Furthest Z+ can ever go is the Z axis Homing switch. You cannot move "an additional ..mm" above the switch. The switch...
Try reformatting that PC or try a different computer
Z homes up and away, before XY. Are you accidentally homing to the Bottom? Set limits to the top of the Z axis and adjust $23 accordingly
The solder jumpers are visible in your photo [ATTACH] Learn more here How to Work with Jumper Pads and PCB Traces - learn.sparkfun.com Note we...
Cutting power should not cause any issues. Probably just a loose wire that showed up coincidentally around the same time (or rattled loose from...
What was the symptoms of your 3x failed xPros by the way - just want to get some history based on the influx of questions from you. Regardless of...
It definately does - they are etched into the PCB. See docs:blackbox:microstepping [OpenBuilds Documentation]. They are on the bottom of the...
1) Dial down acceleration and Max Rate values - the vendor you mention is known for supplying high inductance motors. 2) Also see...
You forgot to specify a Feedrate in your CAM or wherever you generated the GCODE. NaN=not a number
You may also want to consider contacting the vendor you purchased from, they will likely be able to provide you with the correct firmware, config...
Without load a motor with a bad connection on one wire often will do just that too yes. Under load it draws more current and that bad connection...
