Separate names with a comma.
Some features disabled for guests. Register Today.
A simple belted system should do the trick without getting into overkill.
The seller notes he can provide a .dxf for the track on a forum post. And as the pinions didn't sell, they may still be available. As far as...
http://www.ebay.com/itm/Nexen-Roller-Pinions-2-Part-966673-RPS25P-BISO050-00MMP3-/301511644069?
Check with Fuzztech. They are showing 50 in stock.
Actually, 4.2mm is for cut threads. For formed threads 4.6mm is recommended. And if I had one, I'd give it a try but as these screws don't have...
@Donald D. Parker, have you tried Autodesk Trueview? It will allow you to print to scale and will work with the dxf files provided in the OX build.
Gray, it all depends on the forces and how they are applied. You would never use the inner wheel mounting the Z-axis carriage to the X-axis as...
Darrell, it all depends on the nature of the system and the forces applied. It might even work with just 4 of the small wheels. I did a mock-up...
Those are no different than the 1000mm C-beam kits where you won't see a support either. The discussion here is in regards to much longer...
Darrell, I understand your confusion with the SKU 900 Extreme V Wheels. Most of the pictures shown on that page are of the Solid V Wheel. This...
Yes, just a smooth hole in a guide block. That is all that's required to provide support. If you tap them, they move with screw movement and the...
You'll actually want the supports to slide freely along the screw rather than be tapped and move with it. Here are a couple suggestions: Connect...
Bill, the useful length of screws maxes out around 4 feet unless you get them in a rather substantial diameter. Igus can supply the length you...
Arctic Silver Adhesive.
Suggestions for integration of the C-Beam Linear Actuators into the OX system. (file attached) Just a few quick ideas. Moving the lower gantry...
Two 1500mm lengths bonded back to back would make one heck of a nice bridge beam for a wide format router table. :)
Where did you find the 1/4-20 nuts that fit the track?
Drawings are on the files tab. Spacing is section depth + 19.8.
