Separate names with a comma.
Some features disabled for guests. Register Today.
...machining job. I did sand the outside edge to remove the four hold down tabs I used to keep the piece in place while it was being cut out. No...
It really does need a spring loaded foot though, had a couple of accidents around the edges where it picks up the material and turns it back on...
I've considered using 2 x Brush draught excluders on each side on the Y axis's. The type that you screw to the bottom of doors. My idea is to put...
Tip I picked up here from @sharmstr - drill and counterbore your spoilboard in line with the supports so that the screws to hold it down will...
Great motto.
This CNC Hold-Down Clamp gives me enough clearance & I have used this one before. I redrew it in Fusion to take out some of the sharp edges....
Haha. That wouldn't be a bad idea if I had complicated setup tasks. In my case, I've optimized my hold-down system to the point where cleaning the...
...This came about today as I was working up plans for the vacuum hold down box. Mainly because there are so many ways you can do the table on the...
...I have to work with!! Would it be possible to add some sort of hold down (clamp or screwed) that we could mount to and tile an 8’ sheet of...
Alright this is a reach but worth a shot. First time posting on a thread like this. I’m a mechanical engineering student that is working with a...
...arrow keys on my keyboard, and it would move correctly. I could hold down the arrow keys and it would move along the chosen axis just fine....
yes, I understand that, but they the extrusion is in the way. For example if I wanted to route a shape that looks like an upside down bowl that...
well at that point in the build that I need to get my spoil board down and since I am not using MDF, it's time for some metal work. I have a...
...thanks for your reply. This is written in the documentation: Hold down the MODE button (keep holding it down) This will tell the controller...
...using this method for these reasons and now I usually screw hold down right into my waste board. It doesn't really hurt anything and it's a...
I use this method a lot when cutting things out of plastic. It works great. What I like about it is that the two layers of tape are thick enough...
...bolt access from above the spoiler. A simple four bolts will hold down more than this machine can handle. I have a few made from acrylic for...
You can glue HDPE with CA glue if you flame treat the surface first. Wave a blowtorch flame over the surface, just fast enough to not melt it,...
Hmmm... I dont have anything under my lower belts, I thought the double tape was only to hold it down. Yes it seems like its only under rapid...
This was bothering me too, especially in gcode generated by SketchUcam, so I modified it and the most recent release will always start the job...
