Separate names with a comma.
Some features disabled for guests. Register Today.
1) make sure the machine jogs the correct ways first 2) homing dir just says where the switches are A must-read is the entire Grbl Wiki at...
No need to, we'd have advised if we felt that was needed - avoid additional unrequested steps - it makes troubleshooting harder as we might have...
Please post one of the failing GCODE files as well so we can help you check it
Did you remember to HOME prior to setting Zero? Also recheck your Post / CAM options as well (Z safe hieghts, start/end of job, etc) and reCAM...
Not at all, but might have one that slipped through QA, or it got damaged somehow during initial installation (No earlier miswiring incidents that...
Yes it will, and its a much better option
Interface or BlackBox? If its the Interface - see Method 2 or 3 of the Firmware Update procedure from docs.openbuilds.com/blackbox to get onto V1.52
How about Sketchup Make 2017 (Last free version)
They say: So you should be able to directly off the PWM output. Contact About Us for specifics on how to wire it to their controller. Section...
No problem, here for you anytime!
We do not have a safe and proven method for that. Sure the controller doesn't accept PWM or some other method too? Link to the product please?
See docs.openbuilds.com/interface > firmware update section for instructions on entering Bootloader mode
Checkout sections 3.3.2 or 3.3.3 of docs:blackbox:start [OpenBuilds Documentation] Also see Grbl v1.1 Laser Mode · gnea/grbl Wiki
Yeah, the CH340 is a great little USB chip for low volume serial data projects, but we do see it choking with Grbl often (just too much data going...
Are you running any form of dust extraction? docs:blackbox:faq-emi [OpenBuilds Documentation] Is the Arduino an "arduino" or an "Arduino(tm)" - if...
See docs.openbuilds.com/interface for wiring instructions - needs a Grbl based controller with accesible UART pins. BlackBox is plug and play with...
1) make sure you followed step 4.2 of docs.openbuilds.com/blackbox or try a different computer 2) make sure your Interface is on Firmware v1.52
Please contact the store via Support for assistance
Yes, you can. You loose a little Z height - but thicker = more rigid so actually better. Or even use Ply, or some other sheetstock instead of MDF...
correct No, You ZERO the "stock" which in this case is the spoilboard. Front, Left, right on top of the surface of the spoilboard
