Separate names with a comma.
Some features disabled for guests. Register Today.
Applies indeed. You need to build a proper queue management system, managing Grbl over serial is at least a couple hundred lines of code. Keeping...
The Y axis motors sounds good, but the X axis does not - probably not a coincidence that its the same axis with the homing issue Same noise when...
For the other video, yes, your wiring is 100% correct, switch positions are correct, BlackBox is working perfectly. Have you ran any test cuts,...
What is the noise there?
OK awaiting the close up videos of the X axis during homing then (:
Please check this closer - videoing the X axis switch on approach and around the time it has to back off - earlier video showed Y axis and quick...
If the Troubleshooting tab reflects the switch status correctly the BlackBox is fine. Did you check the Grub screws and other stuff mentioned in...
The Radeon GPU in the HP should help with WebGL (3D graphics)
Check your acceleration and max rate settings in Grbl Settings - if set too high you can stall the motors. Also check Shaft Couplers on the motors...
Once you have your Hard Limits issue sorted: If you are up for helping to beta test this: GitHub - OpenBuilds/OpenBuilds-MeshCAM-Postprocessor...
Incompatible GCODE would raise different errors: Grbl v1.1 Interface · gnea/grbl Wiki (For example "G-code words consist of a letter and a value....
See docs:software:lightburn [OpenBuilds Documentation] and also see Grbl v1.1 Laser Mode · gnea/grbl Wiki
@Giarc please review Play in the Z Axis / dwell - Lead1010 first - its not flex, we are all seeing some looseness - would like your opinion too -...
Regarding the Interface: Please contact the store via Support thanks! Seperate issue: see docs:blackbox:faq-identify-motor-coils [OpenBuilds...
Ok thanks for confirming. Please log a warranty request via Support > New Ticket
See docs:blackbox:connect-vfd [OpenBuilds Documentation]
Check VFD parameters. Accidentally setting 2 vs 4 pole in motor parameters etc
