Separate names with a comma.
Some features disabled for guests. Register Today.
OpenBuildsCONTROL > Wizards and Tools > Firmware Flashing Tool Select the xPro V3 from the list, rest defaults, select the correct Port and Flash...
Try disabled too. The newer V3s (there was a mid-v3 change at some point) and the V4s definately had $4=1 (Enabled) but some of the older boards...
What controller do you have?
Could post it to https://ip-of-the-PC-running-control:3000/upload instead ? Externally to CONTROL, watch the file for changes and post it when it...
File reading is a little more complicated than that. See OpenBuilds-CONTROL/main.js at master ยท OpenBuilds/OpenBuilds-CONTROL More about the...
For a Grbl based controller to move the motors it only needs: Correct $4 setting Power applied (check psu) Motors wired correctly (incorrectly...
Did you remember to set $4 to the correct value for your xPro. Some needs it as =1 (Enabled) and some older ones were =0 (Disabled) Play with...
As described above. You don't use wheels, you built the frame a little skew - loosen screws and make it properly square and precise (:
Either your Uprights are angled, or the two X rails are not perpendicular to the Y rails. Adjust the uprights or gantry position to correct
OK cool, please contact the store for a warranty return: Support
Are you sure your multimeter is correct - incorrect multimeter setting (AC or amperage instead of DC volts) or flat batteries in multimeter can...
All the components allows a little movement. Loosen slightly, adjust, retighten. Make sure Z uprights are perfectly square to the Y rails first....
Bottom left corner: select Probe Type. If you don't have an OpenBuilds Probe select Custom then click the Gear to edit offsets (offset =...
whooo hoo!
We have different machines (I have an old Ox - runs the same BlackBox with Grbl 1.1 controller, same softwarev (CONTROL), but very different...
Save the GCODE to file, and either upload (http://otherpcip:3000/upload) or copy the file over the network to the PC running CONTROL
Yes, plain Grbl compatible Gcode (gcode is just a text file containing specific commands)
Stock current setting (about halfway) is good for most machines. If that stalls, something is still a little tight yes. Or if you can spin...
Consider the OpenBuilds BlackBox too, runs Grbl, supports Lightburn
Addressed already... Which we fixed in our Post already (back in the days people tried the LinuxCNC or Mach posts as we didn't create one yet)...
