Separate names with a comma.
Some features disabled for guests. Register Today.
Just pass the piece through against a fence, using Tiling https://m.youtube.com/watch%3Fv%3DnHH99VN4JuI Tiling is used all the time for pieces...
See Download the Old Netfabb Basic (Free) – Jules Gilson
PWM is a control signal. The controller board on the laser just reads that to know how much power to put into the laser diode. The driverboard...
Similar to docs:blackbox:connect-3-wire-laser [OpenBuilds Documentation] except they provide a PSU input, no need to wire PSU to the 3 pin connector
Depends what you intend doing with the v-bit? If you just want to make a v-shaped groove along the lines in your CAD file (for example engraving)...
If its just gcode, yes. Test it out
For now probe XY with one of the supported endmills or a precision dowel Then swop in the odd endmill, and just probe Z
Only standard bit sizes are supported by default at this time. Custom diameters is on the todo list for a future firmware update
Yes, just create a gcode file containing your macro gcode on the usb drive, and run it like you would a normal job
Yes it does. 4GB or more ideally
Was hoping it would adjust to 24v. Turn it all the way down as low as it would go, should still be fine. The onboard fan is 24v so keep an eye on...
What is the model number?
You just need one line - and a test piece at an angle. Cut the line, find the narrowest spot, position laser right above this point and measure...
Try OpenBuilds CAM Gcode Creator - Public Beta (millimeters and web based though, but free) Your interaction with the metric system is limited to...
See 2. Connecting the xPro V4 · Spark-Concepts/xPro-V4 Wiki Laser PWM connects to same Spindle PWM terminals as a PWM spindle would. Also see:...
This is quite an old project, if the original author does not reply, rather see: Machine Kits - ACRO System - OpenBuilds Part Store
To clear acrylic, no.
Probably the most dangerous thing i have heard in a while! Bouncing a focussed laser beam upward!? You will be instantly blind. Read Hit in eye...
Different lasers use different frequencies of light. IR/CO2 lasers uses the 10600um wavelengths and Acrylic is opaque at that wavelength. Thus the...
I'd prefer taking a bad PSU out of the setup sooner rather than later
