Separate names with a comma.
Some features disabled for guests. Register Today.
If you have access to a 3D printer, checkout V-Slot connector
Definately as good as it gets!
Exactly where i was headed. Useful widget that one, makes sense to make it re-usable (:
See the Acceleration calculator on RepRap Calculator - Prusa Printers Acceleration and deceleration is a fact of life - you cannot entirely beat...
Must be R14 Polyline: docs:software:file-errors [OpenBuilds Documentation] Sometimes just easier to drop it into QCAD, convert everything to...
1000mm/min is the maximum rate achieved during the move (provided it has enough space to reach it) acceleration and deceleration will add onto the...
I think not, since the dialog is straight out of Metro4. But you can pull the jog buttons out into a function or template, send a pull. That would...
See docs:blackbox:connect-plasma [OpenBuilds Documentation]
Change it out for a leadscrew driven actuator
No, but with a CNC controlled machine your plunge would be done at a set depth and feedrate - removing the inconsistency of the human operator...
The "zero" location is just an offset from HOME. Its stored in EEPROM. Rehoming re-establishes machine coordinates (as accurarely as your...
You could try Safe Mode too
It is less susceptable (Has TVS diodes across the output to clamp reverse voltage) but its still not recommended (:
Visually inspect the cutting edges for chips/rounding. Also check that it is clean. Often a dirty endmill cuts badly like a dull endmill. After a...
Ideally don't spin motors by hand. Jog using software
Sounds like that PC needs a reformat (: It's not a CONTROL problem, its a Windows problem
Reboot to close any running instances that Windows abandoned , then clean up the install locations.
You can slide a full sheet through using "Tiling" - no need to cut it half :) See [MEDIA] and also [MEDIA]
Order some 6*1mm magnets off amazon - they are quite cheap and nice to have spares on hand. Clean the seat before placing a new magnet - if theres...
You can adjust it yes, but also go over all fastners - if its been in use for a bit -some may have rattled loose. Also check your shaft coupler...
