Separate names with a comma.
Some features disabled for guests. Register Today.
You can approach the vendor you purchased from for tech support for the product they sell If that doesn't work out: get a BlackBox (see...
What control board are you using Sure its flashed with standard Grbl?
Its a retired product. Been replaced by Xtreme Solid V Wheel Kit The steel wheels used the rails as long-term consumables. The Xtreme wheels...
at xx:58:10 in the log you can see your controller rebooted (or at least appears to have) Either EMI based USB reset, some other application on...
I've noticed you made contact with the store already as well, please keep your support tickets to one channel, duplication is not need. For...
And perfectly matched (: takes out the risk The other motors may sounds more powerful, or cheaper, or whatever reason, but if, for example, their...
Our High Torque motors are 3A, so you aren't referring to ours here then? If you are running 3rd party motors, not ours, make sure other critical...
True, the default post also uses G28 just to further confuse you - despite homing you also would've had to check where G28 is. No worries, our...
What controller are you using? You use the word interface in lowercase, not sure if you refer to the Software (Web Interface?), or our Interface:...
Yes, we fixed the "bugs" fusion doesn't care to fix - superior post all round Remember to set your WCS Offset in the Setup tab: How to define...
It would be better than TB6600s No need for shielded stepper motor wiring, see docs:blackbox:faq-emi [OpenBuilds Documentation] - stepper motors...
Contact the vendor you purchased from for assistance, our software is designed for use with our accesories
Sign up here :) OpenBuilds Plasma
OpenBuilds CONTROL uses the recommended Character Counting method as prescribed in the Grbl Wiki: Grbl v1.1 Interface ยท gnea/grbl Wiki You don't...
No math involved. We made BlackBox to be "beginner friendly" Factory default is spot on for most of our machines and actuators - just plug it in...
Clip it to the Collet
Downloading V11 now - will update docs this week Definately has Laser Mode enabled... G0=off, G1/2/3=on (as it should for lasers, not for spindles)
docs:blackbox:microstepping [OpenBuilds Documentation] Factory default is good for most, if you need a little more, dial it in:...
Checkout our dust boot for inspiration: Dust Shoe for Routers It uses magnets to allow you to easily remove the brushes for bitchanges, probing,...
Post your Grbl settings please. CONTROL > grbl settings tab > Backup Grbl Settings (lets make sure advanced motion settings weren't changed) Also...
