Separate names with a comma.
Some features disabled for guests. Register Today.
See XYZ Probe Plus with VFDs and other ground-loop inducing components Usually spindle related, but short circuits can be at other spots too....
Is your firmware up to date? V1.51
Soft Limits is a well working principle. You home to set the machine coordinates. Your Max Travel values tells Grbl the safe envelope inside those...
No, for the LEAD1515 high-Z see OpenBuilds LEAD CNC Machine 1515 (60" x 60")
Short circuit from spindle body to DC GND (dangerous) . Using a chinese spindle?
The error states the issue. Your Job is larger than what you configured Grbl to tell it how large your machine is. Either reCAM so the job fits...
Ideally use our motors to ensure optimal compatibility. 3rd party motors: post the datasheets so we can check their electrical specs.
http://support.openbuilds.com/support/home will be able to assist, post screenshot of the code error message - they will be able to assist No plans at...
Uninstall, clean up any remnant files from where it was installed. Reboot. Then install from fresh
The menu item was added to please you
Will fix (: Probe dialog: jog mode not resetting if closed by overlay · Issue #228 · OpenBuilds/OpenBuilds-CONTROL
See our comprehensive guide here: docs:blackbox:faq-emi [OpenBuilds Documentation] Also personal opinion is the low quality amazon switches....
Shout if you get stuck
Up top in CONTROLs Grbl Settings tab, next to the machine selection there is a simple switch for "limit switches installed" flip it ON, click save...
You can wire motors in parallel :) Just check on that 16mm ballscrew idea - big heavy ballscrew (more enertia, slower acceleration) usually has...
Are you adding more L-brackets so the spolboard attaches to these (that would lock them together too) Spoilboard that floats on the braces would...
Temporarilly disable Hard Limits in Grbl setttings
You can use passthrough in this way - but it is limited (remember Interface is intended to replace the PC, not compliment it) Make sure to use a...
Run is disabled until GCODE is loaded. From the open button, your mouse would move downward away from the Run button to reach the Open Gcode menu...
Cool man, glad you found it (:
