Separate names with a comma.
Some features disabled for guests. Register Today.
IoT takes control voltage of 3-60VDC or 12-120VAC (: We would not document it if it would not be OK (:
I'd say there are too many variables (friction, acceleration, static loads, dynamic loads) not taken into account just yet Experience based...
Calibration is stored on the BlackBox (Grbl parameters are stored in EEPROM: Grbl v1.1 Configuration ยท gnea/grbl Wiki) Interface, CONTROL, any...
1) Does it jog correctly - if not fix your Direction settings in Grbl Settings > $3 Direction Invert first 2) or Did you remember to ZERO the Work...
See it more as inspiration, than a step by step guide, but @Ariel Yahni might have more details - been a while back
Checkout UK40OB
Yeah autolevelling is just an advanced way, no need for it if that boards are simple enough, like I said above: Instead of Fusion though,...
You keep the BlackBox! Autolevelling is a software thing But CONTROL (just one of many Grbl host applications in existance) does not have that...
Nothing hardware wise (wire a clip to the PCB copper surface = GND; and clip to the bit doing the probing = SIG) , Just a host application that...
If they have a Post, then you use HSM express to generate the gcode. Not openBuilds CAM anymore. If you have a Paid advanced CAM, why would you...
No no, the 0-10v output is +-10v, you cannot turn it down that far! See docs:blackbox:connect-vfd [OpenBuilds Documentation] - its for spindles,...
Use the COOLANT output to switch the IoT docs:blackbox:connect-coolant [OpenBuilds Documentation] (Similar to the Vacuum example - you can of...
The 0-10v is doe VFDs. What you have there can damage either the BlackBox or the LPS. DIR is not used.
Reread the Grbl Wiki too. Min RPM changes your scale. Is 0v=off or is 0v=3500rpm. You are telling Grbl to assume the latter. Also make sure to...
Ahh ok, was wondering about the history Do go over his work too - in case shoddy work on his side may present a danger to you Analog meters are...
From: Advice on CO2 Laser Build (linked to from my other reply) So BlackBox GND to G BlackBox PWM to input of your self-built Inverter Circuit,...
See my reply to your duplicate post here: Co2 Laser cutter/engraver using the OpenBuilds BlackBox
K40s doesn't have a TH port, only an L port that needs an active low signal. The 60w+ ones has a proper PSU (info in this thread, does not apply...
M9/M8 in gcode. Or the Tool On menu in CONTROL
Not sure what you mean? But read the Grbl Wiki (: Homing sets Machine Coordinates Setzero sets Work. Coordinates Steps per mm sets travel...
