Separate names with a comma.
Some features disabled for guests. Register Today.
Check grubscrews on shaft couplers - slipping motor shaft or leadscrew inside couplers are hard to spot Also check wiring on X:...
Enclosures help, but every cable entering the enclosure is an antenna More importantly, fixing the Source of the interference is always better...
Not at this time. Keep a conversion chart at hand Magnifying glass - top right corner, or from the Forums > Search forums menu, or direct link:...
Agreed, ease into it. Easier to troubleshoot with less Add more drag chains, one on each side
2) Adding the earthing will probably help a lot of EMI, so I'd suggest beginning there (sooner rather than later) Could be Serial corruption (as...
Go for it, the bigger the radius, the less strain on your wires (:
Good point! Learn more over on https://docs.openbuilds.com/blackbox
Should be a 10mm diameter, but check the screw heads with a caliper if in doubt
As it should. Hitting a limit means something went wrong. Machine crashed, lost position. You have to lock up to prevent more damage. Operator...
Yes, read fhe Grbl wiki for info: github.com/gnea/grbl/wiki The Commands and Interfacing pages relate, as does the Jogging and list of supported...
If it stalled with a high-pitched whine it could be that a) mechanical binding caused stall or b) incorrect Grbl parameters (too high acceleration...
Which needs the 65mm reduction sleeve, which is only sold with the RoutER11 - so he'll have to 3D print one
Checkout the Dewalt 26200 from local suppliers (230v version of the Dewalt 611) Router mount fits 69-72mm diameter bodies
Yes, Z-max travel can be increased by 250mm - not related to your issue though, just good to set properly
Best to approach the laser diode vendors (Jtech or Optlasers) for capability questions and example, but they do have some tests published online:...
You do need NPNs yes, for the default configuration at least, as we need to pull SIG to GND when it triggers. You "might" be able to use PNP,...
Might be your sensors themselves (wrong type, wrong spec, etc. BlackBox need NPN type) Happy to check if you post the datasheet for the sensors...
Correct, all Zeroing operations are related to Centerlines, as the CAM's already offset by endmill radius
