Separate names with a comma.
Some features disabled for guests. Register Today.
Might want to try a more powerful computer - there is a lot going on in the backend, and to maintain reliable, fast command streaming takes a bit...
Well done!!!
Short version: You don't. Something happened, that caused Grbl to enter an alarm mode. The reason for the alarm was serious enough that Grbl went...
See docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation] - perfectly matches the symptoms of a miswired (or only 3 of the 4 wires...
Good catch (: Called it when you mentioned the Hum (;
No easily no, as we just use Electron from upstream as-is - that said - older versions helps test, but its better to update GPU/chipset drivers to...
I did think of something now that you mention it. Between the surfacing pass and the border it does raise Z. Dial back your Z Max rate and...
The unhappy face is a Chromium crash, so likely GPU driver or similar. Old versions are available on...
A picture is a 1000 words (: thanks. Yeah you have me stumped too now. Something slipping , something loose.
Oh you mean the Limit Switch on the Plasma wiring page? Sorry: see Xtension Limit Switch Kit Though you meant our Touch Probe from the way it was...
You need a Grbl compatible CAM or Post. See the software section of docs.openbuilds.com
See post #6 at the bottom of Warning message from fusion 360:
Incorrect, you should NEVER change Gcode by hand... Fix the value in the Post Options! If -10mm (10mm below the limit switch) didn't work for...
There are higher pin count boards too. From the basic Arduino Mega, ESP32, more modern Arduinos etc
Yeah, the support agent will get to yours shortly and type up a reply. Just sit tight (:
See AccelStepper: AccelStepper library for Arduino You can use analog pins as digital outputs too. Each driver has a step+dir = 12 pins. Enable...
You'll get a reply shortly, check your Spam folder too
But what is distance from surfaced top, to bottom of Z axis between the two points. Looking at the cut may indicate the spoilboard is off or...
No, login button is for support agents. Use the New Support Ticket option under "How can we Help you": [ATTACH]
Make sure $1=255 in Grbl Settings, and otherwise, mechanical: - loose shaft couplers are a popular one (looks tight, but perhaps grubscrew is not...
