Separate names with a comma.
Some features disabled for guests. Register Today.
See docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation]
Still helpful to help us with a diagnostic Any 3rd party parts on the machine? Sure the surfacing bit has a 1/4" shank (not a 6mm shank)...
See: XYZ Touch Probe Plus
Contact the OpenBuilds Partstore for assistance - log a ticket via Support
See docs:blackbox:connect-plasma [OpenBuilds Documentation] See [MEDIA]
Checkout docs:blackbox:connect-vfd [OpenBuilds Documentation] and replace the Arduino with a BlackBox Motion Control System
Not at this time, as 2% should enable most good laser modules
If Z was dropping, it would keep on dropping on every pass deeper and deeper until it crashes. What you describe sounds rather like your gantry is...
Possibly because there has never been a 'Lead 1510' from any of the official vendors or resellers, thus best to approach the 'vendor' he bought...
Would be good to check in with the board or machine vendor for support, directly.
A 100k across the output might
The coolant output is mosfet driven, intended to run loads as documented. A Solid State relay draws too little current, is not suitable.
You need Vectric for 3D or VCarving work
You can, its just slow. See Laser Cutting and Engraving Tests - Opt Lasers Compared to a proper CO2 laser ($400ish for a complete K40)
Happy to add a page to the Docs - just haven't had time to write a nice explanation of what Machine coordinates are, why always homing is...
445nm Diode lasers cuts very slowly to be honest (6w is not a lot of power - suppliers that claim more than 6w per diode are just lying, thats the...
Yes, sorry, tagged you in when I was still at a loss before he added: Sorry for the bother (:
Yes, but start and end is the same exact gcode. And thus this is most likely related. Hand editing is not trivial
The used to work part, indicates something changed in a Windows update or similar, tough to track down
While we wait, do you mind posting pics of the accident too - may also have clues Is your setup sufficient that Z didn't "top out" mechanically...
