Separate names with a comma.
Some features disabled for guests. Register Today.
Skipping is usually either: mechanical (loose setscrews on shaft coupler for example, or a binding leadscrew etc) wiring...
MCS = Machine coordinate system = set by homing = G53 = where the machine is WCS = Work coordinates = set by Zeroing, probing or G10 command = G54...
You can wire them up in series or parallel: wiring 8 wire bipolar steppers - Google Search
Did you Remember to HOME prior to setting Stock Zero
Speak to the store via support.openbuilds.com and they will assist thanks
Just hit Home All button right there on the screen side buttons
Interesting, they do hold fine for me, haven't seen the issue pop up in support much either. Maybe tighten just a little more?
Negative, the chance of cracking the plates is too high as the eccentrics excert a lot of force You are using lock nuts right? Mines still solid...
Looks awesome! The rounded bevels revealing the plywood layers is my favourite little detail there! With a little modification, you can make it...
You shouldn't have noticable backlash unless something has been built wrong (: Loose setscrews on shaft couplers, leadnuts not properly tightened...
CONTROL does not need internet. Download it from software.openbuilds.com, copy to a USB drive, take that to the offline PC and install
Its important to read the manual for each PD parameter before commiting it - see what each means, and thus why it may or may not result in the...
Might be: PD001 Source of Run Commands 0：Operator 1：External terminal 2：Communication port 0 PD002 Source of Operating Frequency 0：Operator...
You need a device to control power flow to the motor, which reacts to a PWM or 0-10v signal from the BlackBox/Grbl controller - its hardware: pwm...
You need a PWM Motor controller to run a DC motor. You cannot just connect a motor straight to a control signal, you need a seperate power...
Both indicate a problem with Limit switch wiring, first - by not seeing the signal, second, by shorting V+ to GND and thus shutting down the USB...
Peter Van Der Walt submitted a new resource: V-Slot gear racks - Custom made gear racks designed specifically for V-slot extrusions and machine...
I've been designing, prototyping and testing this drive system for a few years now and feel it is finally ready to share with everyone. Please...
That would be the VFD parameter that sets the source of the speed input to 0-10v. Do you have a PDF link to your exact VFD's manual?
You need a Grbl compatible controller. Get a BlackBox (see docs.openbuilds.com/blackbox) and possibly also replace your motors, power supply and...
