Separate names with a comma.
Some features disabled for guests. Register Today.
Loctite for the win. Adjusting wheels are a maintenence item, also keep in mind to adjust the fixed side too (hole is a little large, bolt can...
The proper Laser DSPs are a little faster and better at engraving. I wouldn't swop (: Its a solid setup. If you had a K40 with the very old...
The OEM style collet is usually the culprit, take it out and you'll see why (mass production). The taper in the shaft is usually not too bad....
Macros, serial console, etc just sends it along to Grbl. As does, the Grbl Settings tab. Did you remember to click Refresh under Grbl settings...
With those high inductance motors from the Knockoff supplier, might even stall out at lower still than 3000. Probably more like 1500 max reliably...
Squedking noise? Lubricate your leadscrews with NB Dry/ptfe lubricant. Do not use oil
See docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation]
If you use CONTROL as the only way to run jobs, the "probe issue" goes away by itself
Credit to @Erik Engstrom for the very thorough original post. With all that information, its super easy to find a root cause. Thanks Erik!
Can poke out the bottom a little. Loosen the stop collars, assemble the top side, then retighten collars
Placement largely depends on what you use the machine for, and what kind of bits you use, how tall the stock is. In fact you might often adjust...
Sure you remembered to change the Bit Diameter field on the probe wizard to the new smaller bit before probing with it after the toolchange?
See https://inventables.zendesk.com/hc/en-us/articles/360012762533-Walkthrough-Tutorial-Exporting-Gcode-from-Easel to get your gcode out of Easel....
When you switch between Easel and CONTROL - connecting in one application, disconnecting in the other, each time the port opens, you "reboot" grbl...
Checkout start [OpenBuilds Documentation] for both BlackBox documentation, but also the Software section Download OpenBuildsCONTROL (think of it...
You can use the same, just make sure your fans are also 24v.
Not about mechanical tightness. Referring to grbl parameters, software settings. Tune down acceleration and Max rate to prevent stalling
Not really no. You are cutting at 1000mm/min by having F1000 with 100% power. S1000 matched your $30=1000 to be 100%. S500 would be 50% for...
Tune your Acceleration and Max rate values in Grbl Settings (instructions in the Grbl wiki at github.com/gnea/grbl/wiki) Being a heavy gantry,...
Can your machine resist the increased cutting forces too? How to calculate V-Slot® deflection High horsepower spindle, big tooling, but on a...
