Separate names with a comma.
Some features disabled for guests. Register Today.
If you shorted V+ to gnd at the limits in particular, you killed the MCU. The USB chip is seperate. Thus the big warnings on the Limit switch...
If you caused a short, its unfortunately dead. Read the warnings in docs.openbuilds.com and order a replacement from...
Negative, I mean the Grbl Settings > Max Rate gnea/grbl of the axis that looses position Nothing attached, photos of your failed cut would help
Loosing zero is usually related having set Max Rate too high in Grbl settings (causing stalling in long moves between parts) - dial it down a...
Known bug, but also hard to handle, as its such a short move its "done" before it started basically.
Refer to docs:blackbox:faq-usb-connection-failed [OpenBuilds Documentation] for the complete procedure. The fact that you posted here, on the...
OpenBuilds CONTROL? Same mouse actions apply as CAM, except that you can't "move it" as that would change the origin. The grid shows you where...
Post the output of a Grbl settings backup please.
Only compatible with controllers with UART pins exposed. As mentioned in the docs.openbuilds.com/interface
Something tucked, something bent too a too small radius, or could even have a bad spot from the factory. Stop overthinking it. Measure out the...
Forget the knockoffs (: low quality, bad instructions. Rather see openbuildspartstore.com
And after that, multimeter the wires in between too. Could have in invisible break, inside the insulation of one of the 4 wires
Then it should just work. Retry, if needed video
PC and Interface both just send the G38 command. No difference at all between the two. Interface Firmware up to date? You are using our Probe...
Unlikely to be gcode related, maybe a nick in a rail causing the jump? Or some other mechanical cause
See docs:software:vectric [OpenBuilds Documentation]
As mentioned above:
Wires broken off inside insulation from a spot with a bit of a lack of strain relief? Terminal that looks good, but has the wire under, instead of...
See docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation]
Best to speak to http://support.openbuilds.com/support/home in that case
