Separate names with a comma.
Some features disabled for guests. Register Today.
John and Jamie, Looks like it's a dead end here, but, I can tell you that I've build a similar machine when the C-Beam was not released yet. The...
I've said this in the xPRO topic as well, so here are just a few quick tips: -Use as short as possible wiring, but make sure the wires are the...
No, you will also not have it set at 2.8A as that's the max. current of the motor per winding will take and thus totally not needed. Those drivers...
Best thing you can do is to buy yourself a miter-block and hack-saw, they always come in handy. OpenBuilds does not provide any cutting service....
Hello David, Mark warned me about you! :D Do you have anything on paper (printable PDF or so) that can be used to translate or given to the...
Naa, it's an Routy Ox YAOR! :ROFL: But great, finally something less boring then and O X, keep the ideas coming! ;) To reinforce plates, use...
Just 3 wheels on each side of the Y-axis? Would not do that, well, at least make some extra holes for future upgrades. V-Slot can be used for...
Hello Jestah, The double nut block might be outdated as the new Anti-Backlash Nut Block for 8mm Metric Acme Lead Screw is now in store. But, you...
I thought about spamming this here as well: [IMG] -Ronald :D
Great, thank you for pointing this out and will take them down from my site as well. -Ronald
You can still use the Threaded Rod Plate for Nema 17 Stepper Motor on both sides. the build is almost the same; just leave the 2x 1 mm shims on...
Hello fellow builders, This is the first project that I would like to share with you. I know the build looks familiar and it is; it’s based on...
It's a suitcase by itself Joe ;). I would keep the back open so you could route bigger parts by sliding it trough the machine step by step. A...
That would sound logic, but in practice it will give you for 99.9% the same results. I forgot that on OpenBuilds we only have the 1.8º motors, I...
I see. Remember that in general your stepper driver will give you an at least 1/2 step (using a l298n only) if I'm right, but most will do even up...
More than strong enough, this is why I suggested a NEMA17 motor before, teaming it with a 14t pulley and your done. -Ronald
I've been building different Routy models and I can say that when you build a machine that has a cutting area of 611*611 mm you are better of with...
I´ve been testing the A-axis on the xPRO and it's hard to say what is exactly the cause of failure. The test included 3 xPROs, 1 from the last...
It's a start and we are happy to show you what can be possible. Now we know it's going to be a 3D printer you might use the "legs" for the Z axis...
Personally I would like to see something different than a belt-drive for a 3D printer but I believe that you are better of using a belt and just...
