Separate names with a comma.
Some features disabled for guests. Register Today.
I had a question on idler. Is the M5 bolt suppose to be able to turn? Is the pulley locked down on the bolt or does it turn free?
I sent you a private message with the shipping cost.
You can get the motors and blocks aligned by loosening the screws so they are free to move. Then lower the bed. That will cause them to align as...
Anyone interested in a set of 6 vertexes in yellow PET-G? I came up with some mods to the vertex that I was wanting to use and then when I could...
Thanks. I had just taken it apart to move the lead screw nuts to the arms. Didn't think about which side the slots should be on. Just made sure...
Carl, question on the Z-bar ends that connect to the vertical rails. Which side should the slotted holes be on? The inside or outside? Or does...
@CapnBry Here is a spool holder I hacked together from parts of other spool holders. There are lots of them out there. Just have to find the...
Has anyone talked about/implemented a dual extruder for this printer? I saw there are dual extruder delta printers so know it can be done. Just...
I used the blue on my printer. Was just checking Amazon since that is where I had been ordering it from. No blue. But did see the red, yellow,...
Was doing some research on advantages/disadvantages of delta printers. Was pretty impressed with the positive attributes of the style so went out...
I went to the website you linked to in the description for the build information, but couldn't find any. Are they still available?
If those fans are anything like the ones we have in some of our servers, you better order some ear plugs too. :)
It goes from room temp to 80C in a minute or so. Haven't actually timed it but it is fast.
I ended up running 24v through the 12v circuit of my heater. Doubled the wattage and it heats up FAST! :) (And yes, it is okay to do this. The...
@CapnBry Wattage is a function of voltage/current (and resistance). While you may only be 1.5A with AC (V*I=W or 120*1.5=180W), running 12v at...
@AK Eric I did some quick research on your Rumba board. While it would be possible to modify the board to do the two drivers/two motors by...
I'll have to do a little research on the Rumba board to describe it better, but you basically take the ENABLE, DIRECTION, and STEP signals going...
That is probably your issue. When you have both steppers on the one driver, each stepper can only get half the current the driver can provide....
The only other hotend I have used is the one that came with my Printrbot. Compared to it, the E3D v6 is a lot better. I guess you could get some...
I'm using an E3D v6 with no problems.
