Separate names with a comma.
Some features disabled for guests. Register Today.
Sweet... It doesn't look too rigid. Odd he didn't make it fold down to the floor, keeping his folded center of gravity relatively high in his...
Go go gadget ... I was thinking of something along this (disregard the dimensions shown, I just grabbed something close off Internet) : [ATTACH]...
Now that could work ... but I would probably end up sleeping in the garage with myOX. I'll for next spring, the winters are way to cold for me to...
Wo ... I need some of those. Not sure what for right now, but they sound like fun to use. Just how precise are they on the feed back ? How fast...
Sounds like a plan ... but counterweights or whatnot could also help if it is a bit heavy to 'flip and tuck' the OX. Thinking the likes of gear...
The table myOX is sitting (bolted on actually) weighs a ton ... not certain the wife would want to park underneath it. :duh:
Yes and no. It could be build vertically ... right up against the supporting wall. But yes, when not in use it could just be flip on its side...
challenges are what makes for inovation ... someone is bound to figure it out, eventually. The counterweights can't just be dangling out back....
A great idea which has surfaced on a recent KickStarter campaign (not using any V-slot or such). It does need a non damaging method of fixing the...
I will move this exchange to my build as I feel I'm starting to crowd this one. See you over at myOX : a 4' x 2' OX... The short of it : has...
Just moving (continuing) a conversation I started over at an other build on the subject of getting my table top flat (more than level as it is all...
Seen quite a few using double sided tape to hold their work piece. Just how strong is that ? It certainly looks practical for jobs with lots of...
I was thinking about one of those, not thinking of adding a sheet of metal on top of it. It looks like a lot of work, starting with getting a...
Tell me about it ... It was no big deal when cutting straight through material, aside from wasting the waste board quicker then anyone would want....
I really like the design. A nice way to get those Y steppers back on the inside of the foot print instead of hanging out ... Just need to make...
Yup ... 1500mm C-beam is available : http://openbuildspartstore.com/c-beam-linear-rail/. I should of checked before the 'post reply'. I usually...
This is how myOX came to be. The X axis is definitely more involved to change then the Y. The latter is just the rails the OX rides on. It can...
I ended using a single screw near the center of myOX's 1500mm X axis to keep both length of V-slot parallel. The front one was flexing (slump...
All great additions many should find very useful ... Looking forward to 'playing' with each one as I get more into SketchUcam ... I just need to...
You guys are going to make my days/nights sleepless. I will definitely give SketchUcam 4D a try, even if it's "simple 4th axis stuff"....
