Separate names with a comma.
Some features disabled for guests. Register Today.
The problem you face here is the A stepper is hardwire cloned to the Y. What you have to figure out is how to unclone A so they can operate...
You might try checking what you have against the Sketchup model. You should be able to pull suitable dimensions off that. As far as returnable,...
Hard to say without knowing their tolerances or the full extent of the problem. You may also need to replace the wheels to get a proper fit.
If I did the conversion right it's around 7.06 scfm @ 100 psi (based on specs provided here). But all this is a subject for another thread....
Learn tiling (pin registration) and that largely eliminates the need to upgrade. Search youtube for "cnc router tiling". You wouldn't be the...
15 scfm through a tiny nozzle will blow away all kinds of heat. Beyond the $355 for the base part, the cost of an industrial sized compressor...
“Duel” ???? :):ROFL::ROFL:
You might be able to get away with it on the side rails on a 500x500 build but honestly I'm not sure if its even worth trying. The cost difference...
There's no real magic to the lengths, you can make them whatever you want. Or you can just go with stock lengths (500mm, 1000mm, 1500mm) like they...
One design is older than the other, power or strength wise there is no significant difference. The Workbee has a slightly greater usable width....
Just bolt on another piece of angle. [ATTACH] You can either thread a hole in the bottom of this angle or if you question the integrity of the...
I would probably be more inclined to cut some 50mm angle into 44mm lengths, drill them similar to common nema 17 mounts and then mount them using...
Couple of options The cheapest: 2/3/4/5/6/7/8mm Flexible Shaft Coupling Rigid for CNC Motor Coupler Connector | eBay A little more robust and...
Plenty of videos on youtube. Search cnc toolpath tiling. Here's one to start off with. [MEDIA]
Interesting design concept. Looks like a fun project and likely within reach of an OpenBuilds system. A couple things to consider though. The...
Truly depends on what you want it to do.
Problem is, you're preaching to the choir here. If you want to get @Spark Concepts attention over this you'd be better off posting on their thread...
Whether or not to reverse a wire pair is contingent on the style machine built. For belted systems one pair on one motor must be reversed, for...
The Hitachi M12VC also has quite a following and may be worth a look. The big question here is what are you hanging it from?
Using tiling (pin registration) the 1010 can cut exactly the same size plywood pieces as the 1510.
