Separate names with a comma.
Some features disabled for guests. Register Today.
Yep: OpenBuilds BlackBox 4X Documentation
No app. No chromebook. There is a jog widget that you can use to control the application from your ipad (or phone), but the main app needs to...
Does it cut correctly in a softer material like plywood? Are your steps per mm calibrated correctly? What are your speeds and feeds? What's your...
Will give that a go. Thank you.
Its setting $23 Homing direction invert. You probably want it set to 3 if ts set to 0 now.
I'm using fusion and you have the option for rectangle or triangular (probably what you refer to as upside down V). I tried some the other day...
Hey Guys. What's a good starting point for tabs in hardwood?
Also, thank you for being so detailed. We appreciate that around here :)
Certainly sounds like you have the wrong pairs. Here's a great writeup on how to check them: C-Beam Machine XLarge Alternatively, if you have a...
LOL
Is not my favorite thing to do. Stop already, Earth.
Ignore the V+ pin. The link I sent you says "TIP: To use Normally-Open switch wiring, ensure that $5=1 in your Grbl settings". In other words,...
Not sure where you're getting GR L D from. The limit switch pins on the blackbox are GND V+ and SIG. Connect GND and SIG to either NO and C or...
LOL. Glad you are sorted.
The pull off value is only used for homing, but I mentioned it because its needed so you dont get alarms after homing. :)
Yes. Kinda hard to explain but if you trigger the switch with your finger, you might notice that it engages and disengages in slightly different...
Also, your settings look good except that you haven't calibrated your steps per mm. Though not at all related to your issue, you should run...
That's EMI then. Is your router power cord running next to the motor wires? If so, move it. Again, do you have a feritte on your usb cable?
Thermal shutdown of the motors? Are you getting red ! on the blackbox next to the motors? With that said, its probably EMI. Do you have...
Did you calibrate your steps per mm when you finished your machine? I cant speak to ob cam or sketchup, but I can say that if your motor steps...