Separate names with a comma.
Some features disabled for guests. Register Today.
We will need more info to help @Johnopc21. What controller (electronics) are you using? What software do you use to send your code to the machine?...
You didn't say what version of the Duet you have, but people with the WiFi version are controlling their Duet with all sorts of devices. How is...
Not sure what the problem is @Handlebar , but once you have set up the Duet any browser can access it if you type the address into it. The Duet...
:) Thanks for letting us know what the problem was - useful for anyone else making the same mistake! Alex:thumbsup:
If you look at 5:12 on the video the bearings do seem to be flush with the outside of the wheel. Alex.
No, I'm not sure - I don't have a belt drive machine, but looking at your pic it looks as though there is more space below the wheel than I would...
In your pics one of the wheels doesn't seem to have the bearing fully inserted - the bearing should be flush with the outside of the wheel. Can...
I'd say you were overtightening the screws, except that the screw is hardly reaching the nylon in the nyloc. Are you sure you have used the 27mm...
Are you setting the origin close to/at home position? Getting a bit late to play with it tonight, but will have a look tomorrow. Alex.
You did make a note of the IP address you set for the Duet? If not I'll try to remember how to find it (it's a long time since I did it). If you...
Any web browser can connect to the Duet Web Control so you should have no problems. Alex.
If Rob's suggestion doesn't work try what you have done above, but deselect "flip X" Alex.
You didn't say, but I assume you are updating to version 7, and that you have followed the instructions and loaded the system settings for your...
Hi @Colin Hart, as @Rob Taylor has pointed out, your g-code is a bit big for your machine. According to the default settings from Ooznest your...
Hi @Colin Hart, on my phone and about to have lunch but will have a look this afternoon. Have you upgraded to V7 firmware? Did you install the...
You won't get a shock from the copper wire - it's connected to earth at one end. On mine I coiled the copper wire loosely and let it "spring" into...
Where have you run the mains cable to your router? If it's in the drag chain or near low voltage wiring take it out and support it in the same way...
I'd say the wonky display is also EMI interfering with the connection between your computer and the display. Better to attach the earth wire from...
Also see here; Stepper motors won't turn Alex.
Dust flowing rapidly through a non-conductive plastic hose build up enormous amounts of static. You need a copper wire - wrapped around the...
