Separate names with a comma.
Some features disabled for guests. Register Today.
Your cam software should set the spindle speed - what software are you using to create your g-code? Alex.
I'm afraid that you need to be aware there are now several "versions" of the workbee around. If it is a version 2 kit the instructions @Christian...
There is some useful information here, but readers should be aware that Ooznest's workbee design has moved on since this report was written and...
Then you need to reduce the maximum travel on your X axis - move the X axis limit switch in enough to stop the dust shoe hitting that side. Copy...
Two things that you can do - I've changed the pause.g file to call homez.g instead of homeall.g. If you want to move to a specific location create...
These are out of date - they go back to the days when Ooznest used G54 as a bodge for machine co-ordinates (should be G53) Tell me what it is that...
It won't move when homing because it thinks the Z switch has been triggered - all homing cycles home Z first so until you re-wire that switch it...
If the led on the board for the Z axis switch goes off when you touch the switch do you mean when you operate the lever or could it be you are...
I've hung the unshielded power lead for my (Chinese clone) Makita above the machine and to the front - low voltage stuff to the back of the...
Will the motor run if plugged into another axis, and will another motor run if plugged into X. IMPORTANT - only unplug or plug in motors with the...
Have you tried running the vfd from a filtered power strip? Alex.
Pretty tough plastic. Keep an eye on the flexible coupler(s) that got distorted though, in case they got weakened by the experience. Hope you get...
3mm spacers + precision shims? It's important to put the precision shims next to the nut blocks - they are slightly larger diameter than the...
Well that's good news - if there is anything wrong they'll put it right. First take the left motor and endplate off and check the end of the Y...
Hmmm - @Peter Van Der Walt's comment made me have another look - it certainly looks as though the leadscrew is not in line with the motor shaft....
Instructions from Ooznest on this bit of the assembly is to have the leadscrew touching the motor shaft - so the coupler is used as a rigid rather...
Also check that you are fully up to date with the Vectric software. If you upgraded recently to version 10.5 there have been problems with several...
Are your limit switches normally open or normally closed? Alex.
The Fusion website is a great place for tutorials - here is one to get you started. Fusion 360 Help Alex.
That's just telling you that you didn't set which work co-ordinate system you wanted to use in the cam (manufacturing) section of Fusion, and it's...
