Separate names with a comma.
Some features disabled for guests. Register Today.
The ER-11 collet maxes out at 5/16ths, so you will be limited to smaller diameter router bits. More than likely won't effect you, but for me, I...
Can be bought here (6 Pack Universal CNC Controller by Bart Dring on Tindie), but I am posting the link for the details there (I have no...
I'll give it a try, but I should not have to. The board should be stable enough to control the signal well enough to not cause the spindle to...
Slight bump. I measured the voltage across the spindle control and ground.. and after setting a specific speed.. I am seeing fluctuations in the...
See the video below for a visual of the issue. Needless to say, it is annoying. First, I don't think the spindle is running at full speed at all...
I have not heard that the Mesa cards had an ESD problem.. but at the currents and voltages in use in a CNC machine, it is not surprising. The nice...
Someone has a secret credit card his wife does not know about.... :) Why not use a Mesa card? What are you using for a spindle?
I had to create a temporary spacer ring to mount the 43mm spindle. This is the DI mode, so no manual speed control. It won’t even turn on unless...
Might want to wait a few weeks.. unless you are on a budget.. the XPro V5 is due out mid December.. not trying to drive business away from OB, but...
Double zombie thread raise... I bought an AMB/Kress spindle, with digital control. It has 3 wires, 0-10v, 10 - 26v and ground.. I'm guessing the...
I just picked up the AMB 1400 DI. It is a 1.4HP 3500 - 25000 spindle. It is 220V, so I wont be able to get it up and running tomorrow as I am...
We need more pictures.. and videos.. :). btw, thanks for the message, I have not really been online, and my upgrade is not going to happen anytime...
following.. since I am looking to upgrade my 1010
Anyone tried upgrading the lead screw to ballscrews....
Raising a zombie thread.. The link to updating the firmware seems to be perpetually under construction now (is Spark Concepts going through some...
It is.. I just realized that that is analogue, and the one on the header is digital.. so ignore my last question. I'll just run it for now with...
Any particular reason that the 5v is connected to the pin instead of the output 5v screw connector.. or can we... I only ask because I don't have...
I'm curious why you guys did not mount the spindle mount to the beam, and have the beam move for the z axis, that way you could use the additional...
I use Whiteside as well, they are reasonably priced, not too expensive, but not cheap. I have been using their bits for non CNC based routing for...
not to run afoul of forums rules possible suggesting competing projects (if that exists, sorry), but just use cncjs (I have no affiliation with...
