Separate names with a comma.
Some features disabled for guests. Register Today.
Well, I guessed right. The name wasn't exactly cryptic though. :p
With the right thinner it should work... Catalyzed 2K is urethane, after all. Just gotta clean out the gun fast and thoroughly. And watch for line...
Is this my original print coat plan or my modification of Giarc's pre-seal plan? I definitely think the latter has merit.
I was assuming this was after backlash had been addressed, but fair point. :P
That I don't know off-hand, though if the simulation uses grbl's hardware simulation mode then it should. I'd just do a very short hand-code and...
Both of these sound like a mismatch in screw pitch, try removing the gantry and calibrate the two columns/Y carriages separately. See if there's a...
All you should need to write is G4 P3, that's it. G Codes
Blackbox może zużywać do 4 amperów na silnik krokowy. w przypadku systemu z czterema silnikami wymagane jest zasilanie 15 A. (I'm not going to...
Don't run an air-cooled spindle below 120Hz, you'll cook the windings. Water-cooled can go down to 80-100Hz, I think. Manual is most likely either...
As a potentially faster option that I just thought of, set it on the machine (in a G55 position if the initial cure time's long), machine the...
From the look of the spec sheet on the Part Store (Acro kit NEMA 17 motor image links to NEMA 23s, btw) they're very similar to the (2A, 3mH) ones...
And aluminum is specifically an extremely resonant material. We're basically making machine frames out of tuning forks, but it's also cheap,...
Odd. Maybe a current setting, or just a really resonant frame. I'd probably run Trinamics for a sound-sensitive project, but the BB should do ok....
What drivers? Usually cheap drivers are the biggest cause for noise.
Yeah I just looked and it doesn't look like Smooth-On have a urethane thinner either, so maybe it's hard to do for that chemistry. They do have an...
Do Alumilite make a thinner for their resins? Smooth-On make both a thinner and thickener for a lot of their products. It's weaker with a thinner,...
When you're casting in a silicone mold and something like this happens, you do a print coat- a very thin, brushed-on layer of your resin (or...
High-speed strategies don't preclude high-DOC operations- more to do with WOC/chipload than anything- but having done trochoidal slotting (as I'm...
Some updates, which I'd typed out before apparently missing the text box with my drag and drop and the draft didn't save for some reason. One,...
Anything that works with Mach 3/4 or LinuxCNC is expecting a step/dir stream- ie. It’s a driver breakout, not a control. The PC is the control....
