Separate names with a comma.
Some features disabled for guests. Register Today.
I used one of the 24v power plugs. I have to admit, I cheated and that is why there are lights. I only had a 12V fan, so I calculated out how...
Did you enter the correct diameter for your endmill before probing? Or does the probe wizard not require that? I have not yet played with my XYZ...
Was your table flat to begin with? The best way I know of to ensure you have a good rigid and flat surface to mount your machine to is to build a...
That is what I did.
If you are a Microsoft windows 10 user, you have the OneDrive on your computer. I create a project from the comfort of my laptop and reclining...
I would say you could run it fairly fast since you are probably doing a small stepover for carving. I have never used one that small before. For...
VFD Spindle Control via OpenBuilds BlackBox Controller and Software
When you calibrated, how far did you measure? I did the OpenBuilds wizard method in the Control Software, but after getting it as close as...
I found a metal one at a store that sells used scientific and electronic equipment. I cut a hole in it and put a fan and lights inside. I also...
Is this with a pen? If so, Is there a chance there is some flexing of the pen, or bending of the tip?
The Makita RT0701C. I picked that one several years ago due to its lower rpm range.
Oh. I did not see that.
They are nice. I have both the metric and the imperial sets for my Makita. Now it would be cheaper to just buy the Router11 and an additional 4...
I was going to say re-import it as a .dxf, but apparently Fusion 36 likes to make this stuff difficult. I just tried it and it did not seem to...
This is what I love about Estlcam for a CAM solution. It has never had a problem with any .svg or .dxf I have thrown at it. That being said,...
You need to know your microstepping, belt pitch, pulley size, etc... RepRap Calculator - Prusa Printers Mathematical formula here: gnea/grbl
I figured it out. Your plunge rate was around 381mm/min (sorry my version is set to mm and converted it). When I changed it to 1000mm/min (39...
I have never cut anything that large. I do not have Vcarve pro. Are you doing the whole thing with ball nose endmills? If so, that is probably...
What is the feed rate you chose? How large is "larger"? When I am doing 3D carving work I am roughing with a 1/4" ball nose endmill at...
That is a nice looking cabinet, but I can't imagine bending down that far to work on stuff. :)
