Separate names with a comma.
Some features disabled for guests. Register Today.
@Peter Van Der Walt Whats the difference between max and peak.
All Control releases are here: Releases · OpenBuilds/OpenBuilds-CONTROL
The config is stored on the controller, not in Control. You will have to manually re-add any macros you have.
David has a very valid point. Also, you'd need to be certain that Z is in a safe position before initiating your custom homing. Unless of course...
Yep: File open doesnt remember last folder used. · Issue #270 · OpenBuilds/OpenBuilds-CONTROL
Seems to work ok when running from a browser window localhost:3000
Can confirm that file open in .336 will default to last folder used before upgrading. Opened a new issue on github: File open doesnt remember...
No reason to be rude. For issue 1: When the 3D viewer system is disabled, there is no 3d viewer tab. Please reinstall and verify. 3D viewer...
Its clear that it wasnt generated using the OB fusion post processor. Look at the header The OB header has the post name and version.
^^ THIS ^^^
Off the top of my head, I'd think you'd need an arduino or pi to monitor the temp and control the pump. It can communicate to the blackbox by...
[ATTACH]
Either issue the command in the serial console or click on the small button left of the GOTOZERO button.
Correct. It does a pocketing operation. It will move over 1/2" the diameter of the bit. So you can either account for that when you set zero,...
Yes you can start at any position. Perhaps you only think you zero'd the new position.
Refer to developers previous response: Openbuilds vs bCNC control
Check the documentation: docs:interface:prepare-usb-drive [OpenBuilds Documentation] It holds the probing routines and is where you'll copy your...
Yes, EMI is common with VFD. Check out the docs for solutions/suggestions: docs:blackbox:faq-emi [OpenBuilds Documentation]
You dont need to edit the post processor. Just make the blackbox to IOT connection per the directions. docs:blackbox:connect-dewalt-iotrelay...
Go into grbl settings and turn on "limit switches installed" and make sure Homing Cycle is enabled (setting $22)