Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks! That is the kind f drag knife I have. I do have some 1/2" MDF somewhere. I will give it a shot. For my drawing surface I uses a piece of...
Yeah, I did it to see what the error code would be thinking that may be his problem. I have never had the Blackbox 4x selection fail in flashing...
It should also be mentioned that the computer I used has all the drivers loaded that are recommended under the Black box Documents I linked...
I just dug up an Arduino Uno that I used for another project. I plugged it in and selected COM3 which is what the OpenBuilds software detected....
What Windows Software? OpenBuilds? Arduino IDE? If you have all the software and recommended drivers on your computer, then the OpenBuilds...
That is so cool.
I was thinking the green light. My bad.
I have been having a lot of fun drawing large things with my newly rebuilt and enlarged CNC router this weekend, and and finally getting around to...
Then it appears the probe is working That is correct. You are not closing a circuit by just touching one or the other. The magnet needs to be...
Did you install drivers for the Arduino? When you download the Arduino IDE it installs drivers I believe. https://www.arduino.cc/en/software If...
WHen you say you had X and Y, but no Z, were you able to control the X and Y? If so, did you perhaps flash the two axis laser version? If you...
You may need to run a ground wire through your dust collector hose. It may be creating a lot of static electricity leading to EMI.
Are you connecting the wires directly to your controller? Or using a plug? If it only takes the two wires and you are using blue and black, it...
Have you tried flashing it with the OpenBuilds Control software? Or were you using the Arduino IDE?
You need Black and Blue. Blue is signal, Black is ground. Red is for power for the LED if you have a three wire....
If using inches, then yes. Also use the OpenBuilds post processors for Vectric. docs:software:vectric [OpenBuilds Documentation] Also, I am...
He does not mention them, but yes they are listed onscreen. I believe he mentions the nut blocks were already attached prior to the steps which...
How are you trying to flash it? I recently flashed a knock-off Arduino nano I had lying around to test some limit switches and I flashed it with...
When you say "original" do you mean the actual official Italian made Arduino? Arduino Uno Rev3 I flashed one in 2016, then updated it when...
Also, check to be sure your wiring is correct. docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] If it is not an OpenBuilds...
