Separate names with a comma.
Some features disabled for guests. Register Today.
The first question (there will be others when we know the answer to this) - what controller are you using with your machine? Alex.
I was referring to the line at the beginning of your g-code immediately after the G4 line. See @David the swarfer's explanation above. Alex.
This is a lot more informative than your other post. If you remove the G53 G0 Z move Z axis will not move at the start of the job. Your error...
Are you homing your machine? G53 co-ordinates will only work reliably if you establish a home position (the back, right, up corner has to be set...
G28.1 will store a position (it's relative to the home position in your machine co-ordinates system) and G28 will move to the position you stored....
I think @Peter Van Der Walt is suggesting that you create two separate toolpaths. Alex.
What cad/cam software and post processor are you using? It should be possible to add some end code to every job to do what you want. eg;- G53 G0...
You have a problem with tiny arcs - you need to linearise small arcs - an option in the Openbuilds grbl post processor I believe. The *.tap post...
See edits to post above. Alex.
The max feedrate set in the grbl settings on the blackbox take precedence. Alex. PS, I wouldn't expect doc to cause missed steps with that bit -...
DOC is a little bit aggressive for a 1/16" bit at 2.2 mm per pass. Could you post the file from the generic grbl post processor for comparison?...
There's a Chinese seller (not popular here) that sells that VFD. It's a pdf, so I've attached it - is that the one you found? Alex.
Turn the axis by hand until the X gantry is the same distance from the frame ends on both sides, but check that the frame is square (measure the...
As well as checking the diagonals of the frame to check for square, and checking that your X axis is square to the Y axis, tape some thin thread...
Have you checked the connections at the other end of the stepper motor cable? Alex.
[ATTACH] The symptoms suggest a fault in the wiring to your Z stepper. Alex.
Before going down that route have you looked at the Lead 1010 machine? It would seem to meet your needs. Alex. Machine Kits - LEAD Machine - LEAD...
I cut 6082T6 aluminium (very similar to 6061T6) on a workbee with linear rails with a 3mm SINGLE flute, spiral upcut at 1,500 mm/min, 13K rpm, 0.5...
If in doubt, consult an electrician. You can check for mains earth to DC ground with a multimeter but ONLY do so with every mains connection...
This has come up a few times in the past - search the forum for the phrase "train lift". Alex.
