Separate names with a comma.
Some features disabled for guests. Register Today.
Some of the files from Ooznest have not uploaded - I have those files on a different PC, so I'll come back to you when I get that one warmed up....
That is the user interface for a 3d printer. Did you download and extrract the V1.0.7 firmware from Ooznest? If so try the steps in the link...
The Duet uses REP-RAP firmware - Ooznest's User Interface and config files run on top of that. Version 2.03 of the REP-RAP firmware is correct for...
The link you quoted earlier gave the instructions for ALL the versions of the Rep-Rap firmware - which version did you install? How are you...
[ATTACH]
@llukas I'm guessing what version of workbee you have, but better to follow the Ooznest instructions. For now I would suggest NOT updating your...
@llukas, all good, I actually wanted a pic of the left hand side of the Duet board, but I can see what I need - you have an ethernet Duet, but...
The Duet comes with its own control firmware, written as a web page, but stored on the Duet's eeprom and using config files stored on the SD card....
@rcasenhiser, that was a good test, and rules out calibration as the error is the same regardless of the overall depth of the pocket. Another...
Two points, double sided tape is sometimes prone to movement - try using masking tape (good quality blue tape such as 3M) and superglue - tape on...
Difficult to see from a photo (never looks the same as the real thing - especially on a computer) but is that pocket in the walnut the same depth...
I can't answer all your questions, but start by reading this thread;- How to 'Fake the home' Alex.
Search the forum for "speeds and feeds" - there are a few resources available which give starting points suitable for our hobby machines. Eg;...
I think, with unsurfaced plywood, the only test I would trust is the one near the point where you set Z workplace zero. Plywood can vary...
Are you using an upcut bit? Are the pockets consistently the same amount too deep over their whole area? 1.4 mm is a bit much to be accounted for...
If you load a machine profile Openbuilds Control will set up the default grbl settings for you. Alex.
This is quite an old thread (2017), so it's not very suprising if some links no longer work. I did manage to access the build manual, but my...
@Tailcutter, although your Z max speed and acceleration settings should be fine try reducing the acceleration and max speed slightly (the Z axis...
This link will also be useful. LEAD Lathe Alex.
I'm afraid not (considering the price of Aspire that would be quite a bargain!). Have fun with the build - take your time and make sure everything...
