Separate names with a comma.
Some features disabled for guests. Register Today.
That would be part of it for sure yes. BlackBox still has usb chips (FTDI and later versions CP2102s) so that's what we have it built for.
A proper CNC controller like a Blackbox https://docs.openbuilds.com/blackbox-x32 would probably solve software workflow issues, EMI resilience,...
Usb provides 5V power as well. 24v power is on the switch. If you want it off off. Turn off the PC /unplug USB too
Grbl's comms protocol is described in Grbl v1.1 Interface
Convenient way of not upsetting current modals. As you can include the modals you need in a jog command without needing to change them globally
Or even better RoutER11 CNC Kit with ER11 collets
Just be aware that a bad PSU can cause a lot of issues. It might also affect your warranty (If BlackBox gets damaged by a Surge from that PSU...
It lifts up after probing. Take the probe away, then GOTOZERO After probing, it is at Z14 because it found Z0 (mathematically), lifted up the 9mm...
By how much? And double check that you have the correct probe selected under the Probe Type dropdown near the bottom of the Probe wizard window.
Its quite easy: http://svn.io-engineering.com:8080/ Compatibility mode is on Advanced Tab. That said, we don't compile grblHAL with...
Curious, what was it?
It gets even more complicated :) than just amps in = amps out Stepper drivers convert voltages and creates sine waves! They do a lot of work...
1.9's a good start yeah. If you need a little more torque - 2.37. Can go a little higher - but comission it as needed, don't set it higher than...
That's a 2.8A Peak motor. Running setting would be around 1.8-2A. Use DIP switches on driver and table on top cover - set it to 2A. Or even lower...
Which controller do you have?
Our official number is 199.1 - its a rolled screw, precisely 200 is theoretical, but unlikely to be correct. Was there a change in error rate...
swop pins 1 and 2 of one motor only
Off in both direction by the exact same error? X and Y? if so, do post the gcode please
PS: The whole Grbl Wiki is good bed time reading. Understanding the firmware's expectations, configs, ins and outs is a great ease to the learning...
Rapids (G0) is set as a Firmware config (Max Rate): See Grbl v1.1 Configuration Last sentence of the section: "NOTE: This max rate setting also...
