Separate names with a comma.
Some features disabled for guests. Register Today.
AC EARTH and DC GND should be seperate domains The probe runs on the DC domain. If you have EARTH shorted to DC GND its a safety issue firstly,...
Thanks for confirming, please contact the store via Support > New Ticket
Its printed right on top of it. See https://docs.openbuilds.com/blackbox
Did you calibrate? Consistent ovalness could be steps per mm
Relays open and close. No voltage is correct. Test with Continuity Mode
No, you can Probe Z after replacing the bit, just don't Rezero XY - as the centerline of all bits are the same, but their lengths differ.
https://youtube.com/shorts/6r4GHNLfxGg?si=Mh_W9-BztZEO9dMp shows a belt that's not tensioned correctly - pull motor up to tighten
Not that I am aware of, no.
USB cables can deliver 5v, which is enough to boot up the microcontroller, communications and establish connection. If it does not, something is dead.
No need to reprobe X and Y when swopping tools. Zero is already set. Swop bits and rezero Z only.
Have you work through the link provided onscreen? If so, and nothing helped, good chance something did happen to it. The question is somewhat...
Follow the onscreen instructions please. Transfer was just a convenience feature, been removed for a while. Use the SAVE button and Open it in...
Center finding is the same concept. Start with X, Find one edge, note position, find next edge note position. Move to halfway between the two and...
For reference, work through docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] Take the motors off and spin leadscrews by hand...
At some point its worth admitting that belt will only ever be "as good" and selling off the machine for a better machine like a LEAD would be a...
Use a CAM, instead of manually writing Gcode? grbl (and grblHAL) supports a subset of the LinuxCNC standard so LinuxCNC "G-Code" Quick Reference...
Use the Center Finding Macro: Getting started with Javascript Macros in CONTROL / Library of Macros created by the community (Use Ball diameter as...
Only one extra tooth of engagement? Correct positioning doesn't get much better the more teeth are engaged.
Why not probe using CONTROL? Ball radius as XY offset under custom Probe option in the wizard.
Are you using our power supply or a 3rd party? Any other 3rd party components involved? Did you follow all the Important Note sections of the...
