Separate names with a comma.
Some features disabled for guests. Register Today.
Better yes, easier to implement - no. For the price, some compromises needed to be taken
Machine profile in Grbl Settings tab? CUSTOM right at the bottom of the list If you mean flashing tool, as David mentioned:
Our free and beginner orientated CAM is super simple and doesn't bother with Arcs. If you need proper Arcs, use a more advanced CAM
That means you haven't Tuned your Max Rate correctly otherwise it would never be a worry: Grbl v1.1 Configuration Our free and beginner...
That's the old 4X Look at the difference: [ATTACH] While it can't integrate with Fusion, you can prep it manually from CONTROL with Macros:
AC EARTH and DC GND should be seperate domains The probe runs on the DC domain. If you have EARTH shorted to DC GND its a safety issue firstly,...
Thanks for confirming, please contact the store via Support > New Ticket
Its printed right on top of it. See https://docs.openbuilds.com/blackbox
Did you calibrate? Consistent ovalness could be steps per mm
Relays open and close. No voltage is correct. Test with Continuity Mode
No, you can Probe Z after replacing the bit, just don't Rezero XY - as the centerline of all bits are the same, but their lengths differ.
https://youtube.com/shorts/6r4GHNLfxGg?si=Mh_W9-BztZEO9dMp shows a belt that's not tensioned correctly - pull motor up to tighten
Not that I am aware of, no.
USB cables can deliver 5v, which is enough to boot up the microcontroller, communications and establish connection. If it does not, something is dead.
No need to reprobe X and Y when swopping tools. Zero is already set. Swop bits and rezero Z only.
Have you work through the link provided onscreen? If so, and nothing helped, good chance something did happen to it. The question is somewhat...
Follow the onscreen instructions please. Transfer was just a convenience feature, been removed for a while. Use the SAVE button and Open it in...
Center finding is the same concept. Start with X, Find one edge, note position, find next edge note position. Move to halfway between the two and...
For reference, work through docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] Take the motors off and spin leadscrews by hand...
At some point its worth admitting that belt will only ever be "as good" and selling off the machine for a better machine like a LEAD would be a...
