Separate names with a comma.
Some features disabled for guests. Register Today.
Probably changed advanced parameters like spindle freq as defaults should have worked. (Reset to defaults works too after all) - always hard to...
To a point sure, but its hard for us to provide support for their machine specific bits - one would hope they have put in the effort to come up...
Can use the XYZ probe for that. Just flip it upside down (: Not sure of the Duet side of things, we run grbl/grblHAL and our CONTROL software...
Lie about the endmill diameter and use a V-Bit (: Endmill diameter / 2 = offset Cut depth and offset determines how much you are chamfering....
Onscreen error tells you you don't have Python installed Or just use a Windows PC
Exactly, so you still need to put in the effort to tune it right Have a read first (The entire Grbl wiki is gold) Our machines comes with...
Yes, but you aren't getting "EEPROM CORRUPTED" errors - lets not grasp at unrelated ideas Only time a reset makes sense if machine has been...
Literally any CAD :) and most CAMs - all have scaling, rotation, etc tools docs:software:overview [OpenBuilds Documentation]
Ahh OK, helps to begin an issue with the right question off the get go. Let me guess? That message was on the Interface's LCD? If so, you were...
Did you set it up? (But lets wait with plans like this, get it working on USB first, one problem at a time to ease the learning curve)...
Symptoms doesn't line up with a "bad controller" (: they tend to be dead Everything else about the controller is in your control. Perhaps set Z...
and you are zeroing on top of the board? Z not slipping/stalling? (thought the Z clearance has you ram into top of Z axis)
It could be retrofitted (newer Interfaces work a little better with the X32 though): docs:interface:retrofit-x32 [OpenBuilds Documentation] But...
Are you sure you can afford a 20mm safe height above the material without crashing the Z axis? (only needs like 2-3mm to move over the stock...
OK in that case instead of a Fusion file, post the CAM workspace for review OpenBuilds CAM > As you had your toolpaths setup > Save/Load Project...
No need no. Endstop inputs on BlackBox has pullups (in NC pulling it up to a HIGH state when triggered, switch pulls it DOWN when untriggered)...
Spindle turn off = incorrect VFD parameters (Min Freq) 0-3v is Spindle Off. 3-10v = 7200-24000rpm. Can't really send more than 10v if you...
Both referring to CONTROL, CONTROL is not a CAM :) Learn more about CAD > CAM > CONTROL docs:software:overview [OpenBuilds Documentation]
I mean Fusion has fantastic Built-in CAM so if you have Fusion you'd typically just use that as CAD and CAM. Exporting to DXF and using another...
Contact your machine manufacturer to provide it to you, or read through Grbl v1.1 Configuration and set it up yourself M3 Sxxx where xxx = value...