Separate names with a comma.
Some features disabled for guests. Register Today.
Exactly that, step by step. Open CONTROL. Go to Grbl Settings tab > Scroll down to $3 Direction Invert. Flip switches as needed to fix any axes...
Switch is used for touchoff on a floating head. So technically yes you do need it. Watch the LEAD 1010 plasma assembly videos to see the floating...
Grab a CNC Electronics Bundle Far superior! See https://docs.openbuilds.com/blackbox-x32 and https://docs.openbuilds.com/Interface
Please continue with the store (reply to your existing support ticket) thanks. No none of that is normal, and with both replaced, even weirder....
All the extra shielding/earthing might be messing with it.. Wire it as shows in the docs. Nothing extra Shielding can cause more problems than it...
CONTROL > Grbl Settings > $3 Direction Invert. Flio switches to opposite of what it is now for any axis going wrong. Assuming all the other...
Restore your last good backup. CONTROL > Grbl Settings tab > Restore Backup button on main toolbar > pick that backup file you saved when all was...
CONTROL > Grbl Settings > Scroll down to Max Travel Grbl v1.1 Configuration Grbl Wiki a must-read
You can use Soft Limits (that will jog to just shy of the Home -> Max Travel rectangles extents) - remember to home to establish the coordinate...
Set $44=3 and $45=0 in Grbl Settings It's a 'mask' where X=1, Y=2 and Z=4 (or combination thereof) So the default of $44=4 (does Z first) then...
Ours are Normally open, no way to change.
Refer your controller's manual. V+ = power for signal pullup and filtering circuitry GND = Ground SIG = the endstop signal (Goes LOW [GND] when...
Nothing on the plans, no real need for it with a nicely built machine with a floating head like our OpenBuilds LEAD Plasma THC is more for...
Your thread title states "Blackbox x32 pwm" The PWM port is a 3.3v logic signal yes (See docs:blackbox-x32:layout [OpenBuilds Documentation]...
1) Power on: Does fan spin, does LEDs light up on front 2) Can you still connect over USB 3) If you can connect, do functional tests with a known...
Use the cable tie slots provided on the back panel, couple slots near every cable input, allows you to cable tie the cable for a little extra...
No public schematic available at this time. PSU related damage would likely have extensive damage (regulators, stepper drivers, microcontrollers...
In parallel, you are sharing the driver, so you are compromising on available power. Still under warranty? Or an old controller (If so, consider...
That's what the Prepend/Append blocks are for, add your M3Sxxx where xxx = RPM (or 1000 if its a IoT+Router setup) commands for on and M5 for off,...
Haven't used FlatCAM in a while, does it allow you to pick a gcode flavour/post processor/firmware type anywhere in its settings (Make sure it...
