Separate names with a comma.
Some features disabled for guests. Register Today.
BlackBox runs grblHAL. It accepts grbl/grblHAL compatible gcode. Mainly, the CAM vendor would be in a better position to tell you whether (and if...
1) laser correctly wired (PWM, not Tool Enable for example?) 2) laser module supports PWM? 3) grbl settings correct ($30=1000, $32=1 and rest left...
Normally not like that no: should be M4 right at the start of the job, M5 all the way at the end. In between its G0 moves = off (travel), G1/2/3...
The Grbl Wiki is a must read that explains the settings https://github.com/gnea/grbl/wiki/Grbl-v1.1-Configuration
Yes, the vendor you mentioned is notorious for using cheaper high-inductance motors. Coil resistance, (dictates acceleration performance),...
Same reply as #2 above applies, best option always to restore a backup you took from it when it was working perfectly before you changed settings...
X32 is DC domain only. No connection to AC Earth so can't be there. USB is DC only too. The PC has an AC Earth though so internal short inside PC...
Info always available in documentation: https://docs.openbuilds.com/doku.php?id=docs:interface:start > Preparing USB drive is Section 3.2 Prepare...
Technically tech support for CONTROL is for our customer base, so we can't really help with that one as its a 3rd party controller. Maybe check...
If the firmware is in lockout, it doesn't respond to our connection "are you there grblHAL!?" requests... Its locked
"It" (your question) is a grblHAL firmware development question, not a hardware problem :) (this forum won't be of much help) Terjeio (grblHAL)...
No worries, we have documentation for all products, current and past at docs.openbuilds.com
Older 4X? https://docs.openbuilds.com/doku.php?id=docs:blackbox-4x:connect-vfd (best to specify full name, to avoid us needing to guess. BlackBox...
BlackBox provides the industry standard 0-10v signal: https://docs.openbuilds.com/doku.php?id=docs:blackbox-x32:connect-vfd The VFD manual (and...
Might be better to check in at https://github.com/grblHAL/ESP32/issues especially because it's not BlackBox, but also a little more advanced that...
Always good to start somewhere. If it then stalls slow down, if it feels slow speed it up. Tuning is trial and error, no two machines are exactly...
Post the DXF and we can see if we can see whats wrong with it In essence, must be nice closed vectors (you gotta close the object you draw, draw...
you might want to direct that question at Carveco support, but before you do, with CAMs its very often a problem of garbage-in-garbage out - i.e....
Honestly the laser module vendor is the only party that can really tell you, but if you google around sure others have wired them to 3rd party...
The Laser Module Won't Fire - xTool Support Center shows modules PWM pinout, but the vendor might have better info somewhere [IMG]
