Separate names with a comma.
Some features disabled for guests. Register Today.
That's a new one :) You mean BlackBox X32? Hardware updates are not that often, but there was an update to OpenBuilds CONTROL (the name of our...
Also review earthing and shielding of that cable, even with distance, it can still be a huge broadcast antenna for electromagnetic interference :)
Use the lead 1515 profile and shorten the 1000mm axis you have by 500mm (x or y whichever is shorter)
CONTROL > Grbl Settings tab. If its one of our machines, select machine from list > save and reset when prompted If its a custom machine, you've...
That's incorrect Grbl Settings. You somehow changed/wiped your Grbl Settings. Load your backup you took when it was all working well from Grbl...
Firstly why are you flashing firmware? (if its a damaged controller, failing to connect, it also won't come back from a firmware flash)....
Yes, never run 400hz 3 phase cabling parallel to low voltage signal cabling. It just too extreme, the crosstalk will traverse the shield and then...
That Grbl Wiki linked earlier, is gold, its well worth reading top to bottom for bedtime reading. But yes, checkout Grbl v1.1 Configuration and...
Good stuff, so was a genuine switch hit, not a false trigger
Happy to help, but need that info, what is it you have on there. Old receipts, pictures, anything
What machine do you have? If its one of ours, CONTROL > Grbl Settings tab > Pick a machine from the list, save and reset when prompted If its...
Gcode's correct about 4x4" So machine's steps per mm are incorrect: Grbl v1.1 Configuration Check your steps per mm in Grbl Settings - Get it...
Correct, T1 M6 is not supported by Grbl - please use the correct Post Processors (Our documentation is a must read, much better to read and...
Sounds like the VFD spits out EMI during cutting. Probably badly earthed spindle body, badly earthed VFD itself (PE screw not attached) or using 3...
I hope one does (: - my hands are sadly fully tied on a different OpenBuilds project :(
did it actually hit the switch, or was it a false (did not hit switch but controller saw fake switch hit signal coming off EMI) trigger? If it...
CONTROL > Grbl Settings tab > Z axis Max Travel Grbl v1.1 Configuration
Check your steps per mm in Grbl Settings Get it closer to theoretical values first (based on your motion system) then fine tune calibration using...
Same - on the surface nothing is wrong, so i am stumped too. But lets see maybe the new version does help
Right so first off I installed your Grbl Settings backup. Then I loaded the gcode. Machine is not yet homed - no jogging or setzero yet etc - as...
