Separate names with a comma.
Some features disabled for guests. Register Today.
Since the last update my machine, when pressing start job goes right to the lower right hand corner. the xyz values do not change when joging up...
Some years ago I bought a big ox kit. I like it and have made lots of things with it. The plates that support the x rails and a stepper motor...
I have a program that has some problems. I've found a code that I think is wrong so I went intothe Gcode editor and changed it. It worked fine...
Just had my hard drive changed and now open builds doesn't work. Uninstalled program and reloaded with no luck. This is the screen shot of the...
I'm using sketucam which I have no problem with. From the start point y-0, x-0, it will go to where I have the work set in sketchucam and start...
My open builds black box has been trouble free for the last few months and now the y axis is not holding its settings. During the cut it moves out...
I have a big ox with a Chinese spindle and need to make a dustshoe for it. Are there any pictures around that shows how to build a proper one....
I'm using the centerline tool to cut a slot with a partial curve. The bit will enter the wood then retract then enter and start cutting. The cut...
Have a big ox for the last two years using it with a tiny G. I got it as a kit with a cheap Chinese spindle and today it died. Can I get...
I'm cutting out the inside of a spoon 11/4" X 21/2". I'm using a 3/4" bowl router bit which will give the spoon nice rounded edges. The problem is...
Finely figured out how to get the Gcode into tinyg. Should have watched the sketchucam video more closely. I entered a drawing with holes and...
Just finished my OX. It came with a TinyG and I would like to use GRBL through sketchucam. Where would I find information on configuring the...
I'm just finishing up building my OX. The kit came with a TinyG. Is this compatable with the sketchucam and Gribl? Does it have to be configured?...
