Separate names with a comma.
Some features disabled for guests. Register Today.
Attached is the settings backup. Note the spindle isn't using PWM (but I didn't change that default). I think the issue is that the tool enable...
Yes, it’s the door 2/3 axis firmware. It does trigger the door light and reduces the RPMs on the spindle. But the spindle continues to move...
On the X32, when I'm tripping the door sensor, I can see the door light come on, but for some reason it doesn't turn the tool off. In my case...
Thanks. Is there any documentation on the Relay's? e.g., Which commands activate which piece? I have not seen that in the online docs.
I was swapping out the x4 for the Blackbox X32. When I bought it, I didn't realize that the DIR pin has been replaced with an enable pin. My...
For those that might come along later wondering - I don't think there is a way to set it from the command line (without there being some kind of...
WiFi!123 is 8 characters... as is my other password. But you're right in that it's deleting that character and thinking it's less than 8....
No - it still reads the hold message regardless I think. [10:32:09] [ $$ ] $39=0 ;Enable printable realtime command characters, boolean Then if...
I'm not quite sure what you're suggesting. I ran $39=0 and then tried to run the update... I also tried setting $75=[wifipw] and neither worked....
That’s exactly what I’m doing (plus hitting hard reset button to make sure); however when I go back in and refresh or look at the console, the...
I’ve been trying to update the GRBL settings on my new blackbox x32, but I can’t get it to save any settings. Is there something special that...
I don't know where to put this, but it would be great to have 3 decimal points (or for that to be configurable) on the interface view. The 2...
I see on the github site there's a version 2.09 of the interface software. Is this beta? Does anyone know what's different about it?