Separate names with a comma.
Some features disabled for guests. Register Today.
@BigD, I used ProE to model this machine. The linear movement runs on mini v-wheels. Cheers Anthony
Sorry for the late reply, with regard to the plates I had made, the extra holes in the X-Axis plate were the ones needed if you wanted to use...
Hi, I have attached the dxf's for the plates I had cut, the colour represents the thickness used. Yellow = 3mm; green = 4mm, blue = 6mm if you...
Instead of using the 1/4" aluminum spacer on the fixed side you could use eccentric spacers there too. This helps support the screw better. Just...
@Williams they only differ in length. It probably doesn't really matter which ones you use as long as you are consistent. However, since the...
The pulleys suit 1/4" motor shaft, 20T and are for GT3 belt
If you are looking at a file I posted the 5 hole plates are included only because it was easy for me to have them cut at the same time as the...
Hey guys, I have a few sets of plates left from the last batch I had made. I'm not planning on making any more after these. Please contact me if...
@slittle if you follow the build per the build video you'll find there is not much clearance between the x gantry plates and the 2060 rails. If...
@P. Koon Those are nice looking belts, I suspect the steel reinforcement would help reduce belt stretch. From my limited knowledge on the subject...
FYI, Robotdigg are offering TR8x20 threaded rod stepper motors now. May be a suitable alternative for these kind of printers....
You can send a message through the Parts Store, go to "view messages" in the "My account" section. You should be able to send a message there, the...
Hi Prauk, One of my friends had a similar issue where part way through the job the movements started getting erratic. Turns out the drivers were...
Did you run your table supports across the bed or length ways per the build vid? I used 2 20x80 rails length ways, but with this height there...
The number of t nuts I used seemed like a good idea until I started hammering them into place! Hopefully I won't mess it up to soon. Where are...
Just wanted to share what I've used for my OX table. I used the machine to drill the series of holes in a sheet of 17mm formply, then I pressed...
Here are some conservative measurements from my machine for the cutting area lost due to the shape and size of the Gantry parts. This will vary a...
Having built an Ordbot, a Prusa i3 and a Mini Kossel. I find the cartesian style bots much easier to set up and work with. I've had both the...
One of the side effects of waterjet cutting is the Kerf produced. If you assemble the eccentrics on the jet exit side (I think) the hole is...
Agree 100% here The screws that secure the v-wheels on the "fixed" are not well supported in the spacer block as they are drilled to suit...
